Delta UniSaw 36-L53L - Assembly

8
3
4 5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
31
32
33
34
35
30
Fig. 1
Fig. 2
1
B
2
ASSEMBLY
ASSEMBLY TOOLS REQUIRED
* 1/8" Hex wrench (supplied)
* 5/64" Hex wrench (supplied)
* 7/8" Open end arbor wrench (supplied)
* 7/8"x1/2" Closed end arbor wrench (supplied)
* Various other open-end wrenches or a socket set (not
supplied)
ASSEMBLY TIME ESTIMATE - 2 to 3 hrs.
FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL
THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE
INSTRUCTION MANUAL.
Fig. 1
1. Unisaw
2. Switch (shown with a magnetic starter)
Fig. 2
3. Extension wing (2)
4. Handwheel
5. Blade guard and splitter assembly
6. Upper bracket for splitter
7. Lower bracket for support rod
8. Support rod
9. 7/8" Open end arbor wrench
10. 7/8"x1/2" Closed end arbor wrench
11. Dust chute
12. Miter gage
13. Cap for miter gage handle
14. Handle for miter gage
15. Handwheel lock knob
16. 1/8" Hex wrench
17. 5/64" Hex wrench
18. Hanger for rip fence (2)
19. 7/16-20x1¼" Hex head screw (6)
20. 5/16-18x1" Hex head screw (4)
21. 5/16-18x1" Flat Head Screw (1)
22. #10x1/2" Hex washer head screw (8)
23. 10-32x1/2" Pan head screw (2) (use w/ LVC starters)
24. 3/4" I.D. Fiber washer (1)
25. 5/8" I.D. Internal tooth washer (1)
26. 7/16" I.D. Flat washer (6)
27. 5/16" I.D. Flat washer (2)
28. 5/16" I.D. Flat washer (1) (use w/ magnetic starters)
29. 5/16" I.D. Lockwasher (3)
30. 1/4" I.D. Fiber washer (1)
31. 13/64" I.D. Flat washer (2) (use w/ LVC starters)
32. 5/8-18 Jam nut (1)
33. 5/16-18 Hex nut (1) (use w/ magnetic starters)
34. 1-3/8" Key (1)
35. Spring clip (2) (use w/ LVC starters)