Delta VFD13AMS43ANSAA

Chapter 16 PLC Function ApplicationsMS300
709
API
FEND
－
End of a main program
06
bit device
Word device
16-bit command (1 STEP)
FEND
Continuous
execution type
－
－
32-bit command
－
－
－
－
Flag signal: none
X
Y
M
K
H
KnX
KnY
KnM
T
C
D
Notes on operand usage:
No operand
A contact-driven command is not needed.
 This command indicates the end of the main program. It is the same as
the END command when the PLC executes this command.
 The CALL command program must be written after the FEND command,
and the SRET command is added to the end of the subprogram.
 When using the FEND command, an END command is also needed.
However, the END command must be placed at the end, after the main
program and subprogram.