C-110-170-200E R11 Page 6
Machine Shut Down Procedure
Release trigger and lower down the pressure by loosening the knob on
the lance.
Turn off the High Pressure Cleaner by turning the knob anti-clockwise to
the OFF position. Switch off the main power supply
Once machine stop, depress trigger to release trap pressure in the pump and hose line. Make
sure lance is pointing downwards when doing this as pressure could cause injury.
Once pressure is release, turn off water supply and disconnect inlet and
outlet hose from machine. Dry the machine and store it.
Operations
To prevent accidents from happening, ensure the safety of the person(s) who uses the
equipment and to protect bystanders and nearby placed inventory or machinery, a few safety
precautions needs attention
1) Treat the machine as a high-speed cutting tool.
2) Anyone under the age of 18 is NOT allowed to use the machine.
3) Always use a proper plug and socket specially designed with ground to earth wiring.
4) Only connect to an installation with earth wiring. A certified electrician shall make the
installation. It is strongly recommended that the electric supply to the machine include a
Residual Current Device/GFCI.
WARNING
To Next Page
Loading...
