Den-Sin C-200E - Safety Devices and Precautions

C-110-170-200E R11 Page 8
11) If the machine is to be connected to potable water supply it is strictly necessary to fit the
machine with a water break tank, in accordance with EN1717.
Safety devices
The machine is equipped with the following safety devices:
1) Stop button. The stop button stops the machine when turned anti-clockwise to the 0
position.
2) Locking device on spray-gun handle. The locking device prevents the trigger from being
activated when pulled out.
*Spray gun may change without notice
3) Thermal sensor and over load relay. The thermal sensor and the overload relay protects
the motor against overloading. The machine can be switched on again after a few minutes,
when the sensor has cooled.
DO
DON’T
Locking