MATRIX control panel Safety
PR-2011-0110-GB • Subject to modifications • R9-03-2016 9
3 Safety
The MATRIX control panel is manufactured in accordance with the state-of-the-
art engineering standards and established technical safety codes and regula
-
tions.
The MATRIX control panels are for use intended by the manufacturer. Ensure
proper and reliable operation of the unit before use. Observe all relevant safety
instructions and precautions in the operation manual. Use proper safety mea
-
sures to prevent hazardous situations which, if not avoided, could result in death
or serious injury to the user or property damage-only accidents!
Have all faults repaired by an authorized specialist without delay!
3.1 Identification of safety instructions
The following symbols and notices are provided in appropriate places throughout
this document to designate the safety instructions.
3.2 Safety-conscious work procedures
Observe the following instructions when carrying out installation, adjustment or
repair work:
When carrying out work near low-voltage networks
When carrying out adjustment work on the MATRIX control panel
ELECTRICAL HAZARD!
This symbol indicates a risk of electric shock when working on the equipment.
RISK OF ELECTROSTATIC DISCHARGE!
This symbol precedes a warning on static-discharge damage to the MATRIX
control panels.
DAMAGE TO THE UNIT!
This section specifies procedures and precautions for preventing damage to
the MATRIX control panels.
PERSONAL INJURY!
This section specifies procedures and precautions for preventing personal
injury.
ELECTRICAL HAZARD!
Disconnect all electric power of the unit and ensure that the power cannot be
inadvertently switched on; earth, short-circuit, and block off all neighboring live
parts. Non-compliance can lead to death or serious injury.
To Next Page
Loading...
Need help?
General
