Denon ADV-M71 User Manual (English)

Other manuals for Denon ADV-M71

Operating Instructions112 pages

Specifications2 pages

Questions and Answers:

M
Michelle AllenAug 14, 2025
What to do if my Denon Receiver remote control is not working?
- W
  williamhendersonAug 14, 2025
  If your Denon Receiver isn't responding to the remote, here are a few things to check: * Make sure the batteries aren't dead. If they are, replace them. * Ensure you're close enough to the unit and there's nothing blocking the signal. * Verify you're pressing the correct button and that the batteries are inserted correctly. * Confirm that the remote control mode is properly selected. For operating this unit, use the DVD mode.
Z
zcaldwellAug 17, 2025
How to fix a Denon ADV-M71 Receiver when the subwoofer has no sound?
- A
  antonio66Aug 18, 2025
  If your Denon Receiver's subwoofer isn't producing sound, try these solutions: * Ensure the subwoofer is powered on. * Check the receiver's setup to confirm the subwoofer setting is set to “Subwoofer” and not “No”.
C
Carlos SchmidtAug 21, 2025
Why is my Denon Receiver display on but there is no sound?
- J
  Jessica Jones MDAug 21, 2025
  If the display on your Denon Receiver is lit but you're not getting any sound, consider the following: * Check that the speaker cords are securely connected. * Ensure the audio function button is in the correct position. * Increase the volume level, as it might be set to minimum. * Make sure muting is off. * If using digital signals, verify they are being input correctly or that the correct input jacks are selected.
M
Mckenzie DavisAug 25, 2025
What to do if my Denon ADV-M71 monitor doesn't display an image?
- U
  ugloverAug 26, 2025
  If your monitor isn't displaying an image from your Denon Receiver, try the following: * Check the video output jack connections between the unit and the monitor to ensure they are correct. * Verify that the input setting on your monitor TV is set to the correct jack where the video input is connected.
R
reesetylerAug 27, 2025
How to troubleshoot a Denon ADV-M71 that has no power and no sound?
- B
  Brian AyersAug 28, 2025
  If the display is not lit and no sound is produced when the power switch on your Denon Receiver is set to on, check that the power cord is plugged in securely.
A
April WeaverAug 31, 2025
Why is there continuous noise when receiving FM programs on my Denon ADV-M71?
- R
  Robert GrayAug 31, 2025
  If you're hearing continuous noise when receiving FM programs on your Denon Receiver, ensure the antenna cable is properly connected and consider connecting an outdoor antenna.
A
Alyssa PhamSep 3, 2025
What causes hissing noise when receiving AM programs on my Denon ADV-M71 Receiver?
- B
  Brandy BishopSep 3, 2025
  If you hear hissing or continuous noise when receiving AM programs on your Denon Receiver, it could be due to interference. Try turning off nearby TVs and changing the position and direction of the AM loop antenna.
S
Sherry ReedSep 6, 2025
What to do if Denon ADV-M71 playback does not start?
- S
  Sarah ParkSep 7, 2025
  If playback doesn't start or stops immediately on your Denon Receiver, let it stand for 1 or 2 hours to eliminate condensation. Also, wipe off any dirt from the disc.
J
Jeffrey RoseSep 10, 2025
Why is there a humming noise when receiving AM programs on my Denon ADV-M71?
- E
  Evan WolfeSep 10, 2025
  If you're hearing a humming noise when receiving AM programs on your Denon Receiver, the radio waves transmitted over the power cord may be modulated. Unplug the power cord, flip the plug over, and plug it back in.

Denon ADV-M71 Specifications

General

Channels	5.1
Total Harmonic Distortion	0.7%
Dolby Digital	Yes
DTS	Yes
Tuner	AM/FM
Input Sensitivity	200 mV
Speaker Impedance	6 ohms
Type	AV Receiver
Frequency Response	20 Hz - 20 kHz
Inputs	1 x Optical, 1 x Coaxial
Outputs	subwoofer