Denon AVC-1530 - Audio Section; Video Section

Audio Section
Do
not
plug
in
the
power
card
until
all
connections
have
been
¢
If
hum
or
other
noise
is
produced
when
the
ground
wire
is
completed.
connected,
disconnect
it.
*Be
sure
to
connect
the
left
and
right
channels.
properly
(left
2
Noise
or
humming
may
be
generated
if
a
connected
with
left,
right
with
right).
component
is
used
independently
without
turning
the
elnsert
the
plugs
securely.
incomplete
connections
will
result
power
of
the
AVC-1530/1530G
on.
If
this
happens,
turn
on
in
the
generation
of
noise.
the
power
of
the
AVC-1530/1530G.
«Note that binding pin piug cords together with power cords
or placing them near a power transformer will result in the
introduction of hum or other noise.
Turntable {MM cartridge)
NOTE:
The amplifier cannot be used
with MC cartridges directly. Use
a separate head amplifier or
step-up transformer.
CD player
Ground wire
DAT (for recording and playback)
or
Tape deck
OUTPUTS
Rot
12
coe ee
Nee cere ee seen eet Set mane me 1
The AVC-1530/1530G is equipped with VIDEO AUX
jacks on the front panel for playback of video
equipment. This permits video cam-corders with
playback functions as well as other equipment to
be connected.
A note on the jacks ‘
The input selector for the S inputs and that for the pin
jack inputs work in conjunction with each other.
But the S input and output jacks and the pin-jack input
and output jacks on the AVC1530/1530G have inde-
pendent circuits, so the signals input to the S input
jacks are only output from the S output jacks, and the
signats input to the pin-jack input jacks are only output
from the pin-jack output jacks. Remember this when
connecting the AVC-1530/1530G to a component
equipped with S jacks, and refer to the manuats of the
different components.
8 ee ees
Video Section
Cam corder
“LD player, CDV player, BS tuner, etc.
Video deck
AVC-1530/1530G
(This amplifier)
|
| i
|
“DAV _—
|
Continued
VIDEO
our
Saar aa a, ee Ee Oks L/OLSL