Denon AVP-A1HD - Manual Setup; Speaker Setup; Speaker Configuration; Subwoofer Setup


Getting Started Connections Playback Remote Control Multi-Zone Information Troubleshooting Specifications
Make detailed settings for various parameters
Speaker Setup
Use this procedure to set the speakers manually
or if you wish to change the settings made with
the auto setup procedure.
F Menu tree F
Manual Setup
Speaker Setup
a Speaker Configuration
s Subwoofer Setup
d Distance
f Channel Level
g Crossover Frequency
h THX Audio Setup
j Surround Speaker
Manual Setup
Front
Select front speaker size.
[Selectable items]
Large Small
a Speaker Configuration
Select speaker configuration and size.
(bass reproduction capability)
Center
Select center speaker use and size.
[Selectable items]
Large Small None
Subwoofer
Select subwoofer use.
[Selectable items]
Yes No
Surround A
Select surround speakers A use and size.
[Selectable items]
Large Small None
Surround B
Select surround speakers B use and size.
[Selectable items]
Large Small
None
Surround Back
Select surround back speaker use and size.
[Selectable items]
Large Small None
2spkrs 1spkr
• Select “Large” or “Small” not according to the physical size of the
speaker but according to the low frequency reproduction capabilities
based on the frequency set at “Crossover Frequency” (vpage 30,
31).
• When “Front” is set to “Small”, “Subwoofer” is automatically set to
“Yes”.
• If “Subwoofer” is set to “No”, “Front” is automatically set to
“Large”.
• If “Surround A” is set to “None”, “Surround B” and “Surround
Back” are automatically set to “None”.
• When using just one surround back speaker, connect it to the left
channel (SBL).
• To take full advantage of the performance of the Home THX certified
speaker systems, set the front, center and surround speaker size
parameters to “Small” and the subwoofer to “Yes”.
Large
: Select this for a large speaker with strong bass
reproduction.
Small
: Select this for a smaller speaker with weaker bass
reproduction.
s Subwoofer Setup
Select subwoofer output configuration and bass signal for
playback.
Configuration
Select number of subwoofers and configuration.
[Selectable items]
1SP 2SP L/R 2SP MIX 3SP L/R/LFE 3SP MIX
• THX recommends LFE–THX– mode so that bass interference is less
likely to occur in the room.
• This can be set when the GUI menu “Speaker Configuration” –
“Subwoofer” is set to “Yes”.
• Play music or a movie source and select the mode offering the
strongest bass.
• Select “LFE+Main” if you want the bass signals to always be
produced from the subwoofer.
Mode
Select bass signal for playing with the subwoofer.
[Selectable items]
LFE–THX– LFE+Main
When “2SP MIX” or “3SP MIX” is selected, “Subwoofer 1”,
“Subwoofer 2” and “Subwoofer 3” are each displayed.
Subwoofer Configuration Subwoofer Connector
1SP SW1
2SP L/R
L SW1
R SW2
2SP MIX
1 SW1
2 SW2
3SP L/R/LFE
L SW1
R SW2
LFE SW3
3SP MIX
1 SW1
2 SW2
3 SW3
Setup