To Next PageTo Next PageWhat does “CHECK XM TUNER” mean on my Denon AVP-A1HD?
If your Denon Amplifier displays “CHECK XM TUNER”, confirm that the XM Mini-Tuner is fully seated in the XM Mini-Tuner Dock and check that the XM Mini-Tuner dock cable is connected to the AVP-A1HDCI.
What does “CHECK ANTENNA” mean on my Denon AVP-A1HD?
If your Denon Amplifier displays “CHECK ANTENNA”, check that the amplifier's XM connector and the XM Mini-Tuner and Home Dock are properly connected.
Why are there no test tones on my Denon AVP-A1HD?
If test tones are not produced when you press the TEST button on your Denon Amplifier's remote, ensure that the surround mode is set to “STANDARD” (Dolby/DTS Surround) or “HOME THX CINEMA” mode.
Why can't I play files from my computer on my Denon AVP-A1HD Amplifier?
If files stored on a computer cannot be played on your Denon Amplifier, it might be due to the files being in a non-compatible format; record in a compatible format. If you are attempting to play a file that is copyright protected, note that these files cannot be played on the set. Also, the USB port on the set cannot be used for connection to a computer.
What to do if my Denon AVP-A1HD remote control is not working?
If the remote control isn't working properly, try these steps: Replace the batteries with new ones. Ensure you're operating the remote within the specified range. Remove any obstacles between the remote and the main unit. Check that the batteries are inserted correctly, matching the polarity marks in the battery compartment. Move the unit away from strong light sources that may interfere with the remote sensor. Lastly, make sure the remote ID of the main unit and the remote control match.
How to troubleshoot no sound from my Denon Amplifier subwoofer?
If you're not getting any sound from the subwoofer, first ensure the subwoofer is powered on. Check that the “Subwoofer” setting at “Speaker configuration” is set to “Yes”. Verify that the subwoofer is properly connected. Also, check that the subwoofer's volume is turned up to an appropriate level.
What to do if my Denon AVP-A1HD Amplifier has no picture?
If no picture appears, first check the connections between the amplifier and the monitor. Ensure the monitor’s input setting is correct. If “PURE DIRECT” mode is enabled, cancel it. If you are using component input connectors for the player and video/S-Video output connectors for the monitor, note that high definition signals are not down-converted; set the player to interlace signals.
Why does my Denon AVP-A1HD Amplifier power turn off suddenly?
If the power turns off suddenly and the power indicator flashes red, the set may be damaged. Turn off the power and contact a DENON service center.
General| Receiver type | Surround |
|---|---|
| Input sensitivity | 200 mV |
| Audio output channels | 7.1 channels |
| Signal-to-Noise Ratio (SNR) | 102 dB |
| Total Harmonic Distortion (THD) | 0.005 % |
| Power output per channel (1KHz@6 Ohm) | 170 W |
| Power output per channel (20-20KHz@8 Ohm) | - W |
| RS-232 ports | 2 |
| Connectivity technology | Wired |
| Speakers connectivity type | XLR |
| Multichannel pre out connectivity | RCA |
| Ethernet LAN | Yes |
| Supported radio bands | - |
| Optical drive included | No |
| HDMI version | 1.3a |
| Product color | Silver |
| Audio decoders | Dolby Surround, DTS-HD |
| USB 2.0 ports quantity | USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them. |
| Apple docking compatibility | Not supported |
| HDMI in | 6 |
| Audio (L/R) in | 10 |
| Composite video in | 8 |
| Digital audio optical in | 5 |
| Ethernet LAN (RJ-45) ports | 1 |
| AC input voltage | 230 V |
| AC input frequency | 50 Hz |
| Power consumption (standby) | 0.3 W |
| Power consumption (typical) | 150 W |
| Composite video out | 3 |
| Audio formats supported | AAC, FLAC, MP3, WAV, WMA |
| Image formats supported | JPG |
Weight and Dimensions| Depth | 214 mm |
|---|---|
| Width | 434 mm |
| Height | 485 mm |
| Weight | 27500 g |
