To Next PageTo Next Page
Need help?Do you have a question about the Denon AVR-1509 and is the answer not in the manual?
General| Power Output | 75 W per channel (8 ohms, 20Hz-20kHz, 0.08% THD) |
|---|---|
| Number of Channels | 5.1 |
| HDMI Inputs | 2 |
| HDMI Outputs | 1 |
| Response Bandwidth | 10Hz-100kHz |
| Signal-To-Noise Ratio | 98 dB |
| Total Harmonic Distortion | 0.08% |
| Input Impedance | 47 kOhm |
| Input Sensitivity | 200 mV |
| Tuner Type | Digital |
| Tuner Bands | AM/FM |
| Preset Station Qty | 56 |
| HDMI Switching | Yes |
| Output Impedance / Channel | 8 ohms |
| Frequency Response | 10Hz-100kHz |
| Digital Audio Inputs | 2 Optical, 1 Coaxial |
| Dolby Formats | Dolby Digital, Dolby Pro Logic II |
| DTS Formats | DTS, DTS Neo:6 |
| Surround Sound Effects | Virtual Surround |
| Audio D/A Converter | 192kHz/24-bit |
| Output Power / Channel | 75 W |
| Tuner Frequency Range | FM: 87.5-108 MHz, AM: 522-1611 kHz |
| Video Inputs/Outputs | Component video input (2), Component video output (1), Composite video input (4), Composite video output (2) |
| Analog Audio Inputs/Outputs | 4 Analog Audio Inputs, 1 Analog Audio Output |
Heed label cautions. Avoid electric shock, use gloves for high voltage parts. Prevent finger injury from burrs.
Use only designated parts. Mount parts and arrange wires as originally. Follow safety guidelines strictly.
Inspect all connections, parts, and wires. Conduct insulation check to ensure safety after servicing.
Procedure for adjusting audio section idling current using test points and VR controls. Requires DC voltmeter.
Details specific adjustment steps, including presets, test point voltage settings, and channel adjustments.
Troubleshooting for power problems: 'Power not turn on' and 'Fuse is blown' scenarios.
