7
Set the various surround parameters
l
CINEMA EQ setting
- CENTER WIDTH setting
- DEFAULT setting
lo;@
fj z 0)
% Select “Yes” to reset to the factory defaults
8
Press the ENTER button to finish surround parameter mode.
(Remote control unItI
Surround parameters @
Pro Logic II Mode:
The Cinema mode is for use with stereo television shows and all
programs encoded in Dolby Surround.
The MUSIC mode is recommended as the standard mode for
autosound music systems (no video), and is optional for A/V
systems.
The Emulation mode offers the same robust surround processing
as onginal Pro Logic in case the source contents is not of optimum
quality.
Select one of the modes (“Cinema”, “Music” or “Emulation”).
Panorama Control:
This mode extends the front stereo image to include the surround
speakers for an exciting “wraparound” effect with side wall
imaging.
Select “OFF” or “ON”,
Dimension Control:
This control gradually adjust the soundfield either towards the front
or towards the rear.
The control can be set in 7 steps from 0 to 6.
Center Width Control:
This control adjust the center image so it may be heard only from
the center speaker; only from the left/right speakers as a phontom
image; or from all three front speakers to varying degrees.
The control can be set in 8 steps from 0 to 7.
NOTE:
l
When making parameter settings, the display will return to the
regular condition several seconds after the last button was
pressed and the setting will be completed.
37
To Next Page
Loading...
Need help?
General
Weight and Dimensions
