Denon AVR-1723 User Manual

16
SPECIAL MODE
Special mode setting button
b
No.1 - 9 : Press the
X
button to turn on the power while pressing both the button A,B and the button C at the same time.
b
No.10 : Turn on the power, then press and hold down A and B buttons for over 3 second.
No. Mode Button A Button B Button C Contents
1
Version display
(μcom/DSP Error Display)
DIMMER STATUS -
Firmware versions such as Main or DSP are displayed in the
FL manager. Errors are displayed when they occur.
(Refer to 18 page)
2
Displaying the protection history
mode
DIMMER STATUS
ZONE2
SOURCE
(AVR-1713E3)
TUNER
PRESET CH +
(Other model)
The protection history is displayed.
(Refer to 21 page)
3
User Initialization mode
(Installer Setup settings are not
initialized.)
SOURCE
SELECT
0
SOURCE
SELECT
1
-
Backup data initialization is carried out.
(Installer Setup settings are not initialized.)
4
Mode for switching tuner
frequency step (E2 model Only)
DIMMER
SOURCE
SELECT
1
-
Change tuner frequency step to FM:200kHz/50kHz STEP.
Press the SOURCE SELECT
0
/
1
to select "Mode for
switching tuner frequency step", then press the "STATUS"
button to set.
Turn the power off in this state and turn the power on again to
make the setting take effect.
5
Mode for preventing remote
control acceptance
ZONE2
SOURCE
(AVR-1713E3)
TUNER
PRESET CH +
(Other model)
SOURCE
SELECT
1
-
Operations using the remote control are rejected.
Press the SOURCE SELECT
0
/
1
to select "RC LOCK On",
then press the "STATUS" button to set.
(Mode cancellation: Execute the same button operations as
when performing setup and select "RC LOCK Off".)
6 Panel lock mode
ZONE2
SOURCE
(AVR-1713E3)
TUNER
PRESET CH +
(Other model)
SOURCE
SELECT
1
-
Operations using the main unit panel buttons or the master
volume knob are rejected.
Press the SOURCE SELECT
0
/
1
to select "FP/VOL LOCK
On", then press the "STATUS" button to set.
7
Panel lock mode
(Master volume is not locked.)
ZONE2
SOURCE
(AVR-1713E3)
TUNER
PRESET CH +
(Other model)
SOURCE
SELECT
1
-
Operations using the main unit panel buttons are rejected.
Press the SOURCE SELECT
0
/
1
to select "FP LOCK On",
then press the "STATUS" button to set.
8 Cancellation of panel lock mode
ZONE2
SOURCE
(AVR-1713E3)
TUNER
PRESET CH +
(Other model)
SOURCE
SELECT
1
-
Panel lock mode is cancelled.
(Mode cancellation: Execute the same button operations as
when performing setup and select "FP LOCK Off", then press
the "STATUS" button to set.)
9 Diagnostic mode DIMMER STATUS
ZONE2
SOURCE
(AVR-1713E3)
TUNER
PRESET CH +
(Other model)
This mode is used for conrming the Video and Audio signal
paths. (Troubleshooting)
The signal paths of the set can be easily conrmed after repair.
(Refer to 27 page)
10 Remote ID Setup mode DIMMER STATUS -
When using multiple DENON AV receivers in the same room,
make this setting so that only the desired AV receiver operates.
(Refer to 23 page)

Denon AVR-1723 Specifications

General

Brand	Denon
Model	AVR-1723
Category	Receiver
Language	English