After setting up the system
1
Press the SYSTEM SETUP button to finish system set up.
This completes the system setup operations. Once the system is set up, there is no need to make the settings again unless other components
or speakers are connected to or the speaker layout is changed.
Auto Tuner Presets
Use this to automatically search for FM broadcasts and store up to 56 stations at preset channels A1 to 8, B1 to 8, C1 to 8, D1 to 8, E1 to 8, F1
to 8 and G1 to 8.
NOTE:
• If an FM station cannot be preset automatically due to poor reception, use the “Manual tuning” operation to tune in the station, then preset it
using the manual “Preset memory” operation.
1
Use the CURSOR button to select “Yes”.
“Search” flashes on the screen and searching begins.
“Completed” appears once searching is completed.
The display automatically switches to screen.
2
Press the ENTER or (down) button if you want to start the settings over from the beginning.
• On-screen display signals
Signals input to the AVR-1905/785
VIDEO signal input jack
(yellow)
E
C
E
C
1
2
3
4
S-video signal input jack
E
E
C
C
Video signal output to VIDEO
MONITOR OUT jack (yellow)
C
C
C
E
Video signal output to Color Difference
(Component) Video MONITOR OUT jack
C
C
C
C
On-screen display signal output
(C: Signal E: No signal) (C: On-screen signals output E: On-screen signals not output)
Video signal output to S-
Video MONITOR OUT jack
C
C
C
C
NOTE:
• When a component video signal is input and when the “Video Input Mode” is set to the component fixed mode at Input setup, the on-
screen display is only displayed when the System Setup, Surround Parameters and On Screen buttons are operated.
30
ENGLISH
To Next Page
Loading...
Need help?
General
Weight and Dimensions
