Denon AVR-2112CI

17
STEP 4
Calculate
Set up speakers (Audyssey
®
Auto Setup)
tIn STEP 3, you will perform measurements at multiple positions (two
to eight positions) other than the main listening position.
tJust one position can be measured but measuring multiple positions
increases the accuracy of the correction of acoustic distortion within
the listening area.
10
Move the setup microphone to
position 2, use
ui to select
“Measure”, and then press
ENTER.
The measurement of the second
position starts. Measurements can be
made in up to eight positions.
Audyssey Auto Setup MultEQ XT
Measure (2nd)
Please place the
microphone at ear
height at 2nd
listening position.
Measure
Next Calculate
[RETURN][ENTER] Enter Cancel
If you want to omit measurements from the next position onward,
select “Next
Calculate”.
(Go to
STEP4 Calculate
)
11
Repeat step 10, measuring positions 3 to 8.
When measurement of position 8 is completed, a
“Measurements finished.” message is displayed.
Audyssey Auto Setup MultEQ XT
Measure (Finish)
Measurements finished.
Next Calculate
Retry
[RETURN][ENTER] Enter Cancel
12
On the
STEP 3
screen, use ui
Calculate”, and then press
ENTER.
Measuring results are analyzed, and the frequency response of
each speaker in the listening room is determined.
Audyssey Auto Setup MultEQ XT
Calculate
Now calculating
Please wait
0%
tAnalysis takes several minutes to complete. The time required for
this analysis depends on the number of speakers connected.
The more connected speakers there are, the longer it takes to
perform analysis.
STEP 3
Measure (2nd – 8th)
STEP 2 (Continued)
Detect & Measure (Main)
NOTE
If “Caution” is displayed:
Go to “Error messages” (
vpage 19),
check any related items, and perform the
necessary procedures.
If the problem is resolved, return and restart
“Audyssey
®
Auto Setup”.
When performing Audyssey
®
Auto Setup over
again
Press ui to select “Retry”, and then press ENTER .
When measuring has stopped
q Press RETURN B, to the “Cancel Auto Setup?” prompt is
displayed.
w Press
o to select “Yes”, then press ENTER.
Setting up the speakers again
Repeat the operation from step 4 of
STEP 1 Preparation
.
Basic version Advanced version InformationBasic version
vSee overleaf