Denon AVR-2112CI

70
Playback in ZONE2 (Separate room)
tYou can operate this unit so as to enjoy audio in a room (ZONE2) other than the MAIN ZONE (room where
the unit is located).
tYou can simultaneously play back the same source in both the MAIN ZONE, ZONE2. You can also play
back separate sources in the MAIN ZONE and ZONE2.
Audio output
There are two methods to do this, as described below. Choose one of the methods.
q Zone playback by speaker output
w Zone playback by audio output
Use an external amplifier.
q Zone playback by speaker output
The ZONE2 audio signals are output from this unit’s SURR.BACK/AMP ASSIGN speaker terminals using
the amplifier assignment function.
nConnecting and setting the speakers
“Amp Assign” setting (vpage 86) and
audio signals output
Connecting the speakers
ZONE2
Output signal :
Stereo (L / R)
ZONE2
wqwq
(L) (R)
w Zone playback by audio output
nAudio connections (ZONE2)
The audio signals of this unit’s ZONE2 audio output terminals are output to the ZONE2 amplifiers and
played on this amplifiers.
"69*/
R
L
MAIN ZONE
ZONE2
This unit
tAdjust the volume on the connected amplifier.
tWe recommend using high quality pin-plug cables for audio connections in order to prevent noise.
tAlso be sure to read the operating instructions of the connected devices.
NOTE
It is not possible to play the digital audio signals input from the HDMI, COAXIAL or OPTICAL connectors in
ZONE2. Play using analog connections (in stereo).
Basic version Advanced version InformationAdvanced version