Denon AVR-2112CI

91
Network Setup
Default settings are underlined.
Make network settings.
Setting items Setting details
Network Connect.
Make settings for wired
LAN.
Only set “Network Connect.” when connecting to a network without a
DHCP function.
Network Connect.
DHCP
IP Address
OFF
192.168.0.1
Exit
Detail
q
Network Connect.
DHCP
IP Address
Subnet Mask
Default Gateway
Primary DNS
Secondary DNS
Proxy
Exit
OFF
192.168.000.001
255.255.255.000
000.000.000.000
000.000.000.000
000.000.000.000
w
r
e
q On the menu, select “Network Connect.” –
“Detail” and press
ENTER.
w Use
uio p to set “DHCP” to “OFF”, then
press
ENTER.
The DHCP function is disabled.
System Setup
Setting items Setting details
Network Connect.
(Continued)
e Use uio p or 0 – 9 to input the address and press ENTER.
tIP Address : Set the IP address within the ranges shown below.
The Network Audio function cannot be used if other IP addresses
are set.
CLASS A: 10.0.0.1 – 10.255.255.254
CLASS B: 172.16.0.1 – 172.31.255.254
CLASS C: 192.168.0.1 – 192.168.255.254
tSubnet Mask : When connecting an xDSL modem or terminal
adapter directly to this unit, input the subnet mask indicated in
the documentation supplied by your provider. Normally input
255.255.255.0.
tDefault Gateway : When connected to a gateway (router), input its
IP address.
tPrimary DNS, Secondary DNS : If there is only one DNS address
indicated in the documentation supplied by your provider, input it at
“Primary DNS”. If there are two or more DNS addresses, input the
first one at “Secondary DNS”.
r Use
i to select “Exit” and press ENTER.
Setup is complete.
tWhen connecting to the network via a Proxy server, select “Proxy” and
press
ENTER (vpage92 “Proxy settings”).
tIf you are using a broadband router (DHCP function), there is no need
to make the settings at “IP Address” and “Proxy”, since the DHCP
function is set to “ON” in this unit’s default settings.
tIf this unit is being used connected to a network without the DHCP
function, the network settings must be made. In this case, some
knowledge of networks is required. For details, consult a network
administrator.
tIf you cannot connect to the Internet, recheck the connections and
settings (
vpage12).
tIf you do not understand about Internet connection, contact your ISP
(Internet Service Provider) or the store from which you purchased your
computer.
tWhen you want to cancel the setting during IP address input, press
RETURN B.
Basic version Advanced version InformationAdvanced version
vSee overleaf