ENGLISH
• This  procedure  lets  you  measure  the  acoustic  properties  of  your 
speakers  and  listening  room  and  make  the  optimum  settings 
automatically.
• This  function  provides  the  optimum  listening  environment  for  all 
listening positions in a home theater where several people view or 
listen to the video or audio source simultaneously.
  The measurements are performed by moving the setup microphone 
successively to  the  different positions  where  the  family members 
sit  within  the  listening  area  surrounded  by  the  speakers,  as 
shown in  Example  q. For better results, we  recommend making 
measurements in 6 or more positions.
  Even if the home theater is only used by a small number of persons 
as shown in Example w, measuring at points around the listening 
position results in more effective correction.
Preparations
When using a subwoofer with a setting function, make the following 
settings before starting the auto setup procedure:
  •
  Volume: “Center”
  •
  Crossover frequency: “Maximum”
  •
  Low pass filter: “Off”
  •
  Standby mode: “Off”
NOTE
• Do  not  disconnect  the  setup  microphone  until  the  auto  setup 
procedure is completed.
• When  using  headphones,  unplug  the  headphones  before  starting 
the auto setup procedure.
Auto Setup
To set the listening environment manually to suit your tastes, see page 
26, 27.
1
Connect the included setup microphone to the SETUP 
MIC jack on the main unit.
The “Auto Setup” screen appears automatically.
2
Mount  the  setup  microphone  on  a  camera  tripod, 
etc., and set it at the main listening position, with the 
sound receptor pointing towards the ceiling.
b Adjust the  height  of  the  setup microphone’s  sound receptor so 
that it is at the height of the ears when listening.
Sound 
receptor
Setup 
microphone
About the main listening position (*M)
The  main  listening  position  refers  to  the  center  of  the  listening 
position, or the place where you would sit to watch or listen when 
alone.
This position is used as the basis when measuring the distance of 
the speakers.  
Example q Example w
( :Measuring positions)
Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting