_'1 CONNECTIONS
• Do not plug in the AC cord until all connections have been
completed.
• Be sure to connect the left and right channels properly (left with
left, right with right).
• Insert the plugs securely. Incomplete connections will result in the
generation of noise.
• Use the AC OUTLETS for audio equipment only. Do not use
them for hair driers, etc.
•Nete that binding pin plug cords together with AC cords or placing
them near a power transfermer will result in generating hum er
other noise.
• Neise or humming may be generated if a connected audio
equipment is used independently without turning the power of this
unit on. If this happens, turn on the pewer of the this unit.
• When making connections, also refer to the operating instructiens of the other components.
OUTPUT CD player
R L
Turntable
(MM cartddge/
[ Connecting a turntable ]
Connect the turntable's output cord to the AVR-
2805/985's PHONO jacks, the L (left) plug to the L
jack, the R (dght/plug to the right jack.
NOTE:
__la yi er"_t_.c_gepThisunit cannot be used with MC cartridges
directly. Use a separate head amplifier or step up
If humming or other noise is generated when the
ground wire is connected, disconnect the ground
wire.
_ Ground wire
I Connecting the AC OUTLETS t
AC OUTLETS
SWITCHED
(total capacity - 120 W (1 A.)/
The power to these outlets is turned on and off in conjunction with the
POWER operation switch on the main unit, and when the power is switched
between on and standby from the remote control unit.
driers, TVs or other electrical appliances.
Connecting the pre-out jacks
Use these jacks if you wish to connect external power amplifier(s) to
increase the power of the front, center and surround sound channels, or
for cor/nectior/ to powered loudspeakers.
•_ To use Surround back with one speaker, connect the speaker to
MD recorder, CD recorder or other component
OPTICAL _
R L
INPUT
I Connecting the DIGITAL jacks I
Use these for connections to audio equipment with digital output Refer to "Setting the
Digital in Assignment" (See page 37)
NOTES:
R L
OUTPUT
AC 120 V, 60 Hz
Turn the DC 12V voltage on and off for the individual functions.
For details, see "Setting the Tdgger Setup" (See page 441
CD recordel or Tape deck
83oo _o
I Connecting a tape deck I
Connections for recording:
Connect the tape deck's recording input jacks (LINE Hq or REC/to tMs Uilit's tape
recording (CDR/TAPE OUT/jacks using pin plug cords.
Connections for playback:
Connect the tape deck's playback output jacks (LINE OUT or PB) to this unit's tape
playback (CDR/TAPE IN/jacks using pin plug cords
To Next Page
Loading...
Need help?
General
