Denon AVR-3311 User Manual

9
ENGLISH
Basic version Advanced version InformationSimple version
12
8VHuiWRVHOHFWWKHLWHP\RXZDQW
WRFKHFNDQGWKHQSUHVV
ENTER
>@
67(3&KHFN
&KHFNSURFHVVLQJUHV
XOWV7RSURFHHGSUHVV
´1H[Wµ
6HOHFWLWHPWRFKHFN
6SNU&RQILJ&KHFN
'LVWDQFH&KHFN
&K/HYHO&KHFN
&URVVRYHU&KHFN
1H[W6WRUH
$8726(783
$8'<66(<$8726(783
(17(5 (QWHU 5(7851 &DQFHO
0XOW(4;7
• Subwoofers may measure a greater reported
distance than the actual distance due to added
electrical delay common in subwoofers.
• If you want to check another item, press
RETURN.
13
8VH ui WR VHOHFW ³1H[W 1 6WRUH´
DQGWKHQSUHVV
ENTER
Set up speakers (Audyssey
®
Auto Setup)
STEP 4
Calculation
STEP 5
Check
14
6HOHFW³6WRUH´DQGWKHQSUHVVENTER
Save the measurement results.
>@
$8726(783
$8'<66(<$8726(783
67(36WRUH
1RZVWRULQJ
3OHDVHZDLW

0XOW(4;7
>@
67(36WRUH
3UHVV´6WRUHµWRVWRUH
FDOFXOD LRQUHVXOWV
$SSO\DQGVWRUHPHDVXUHPHQWUHVXOW
6WRUH
$8726(783
$8'<66(<$8726(783
(17(5 (QWHU 5(7851 &DQFHO
0XOW(4;7
• Saving the results requires about 10 seconds.
• If the measuring results are not to be saved,
press
RETURN. A message “Cancel Auto
Setup?” will be displayed. Press o then select
“Yes”. All the measured Audyssey Auto Setup
data will be erased.
NOTE
During saving of measurement results, be sure
not to turn off the power.
15
8QSOXJWKHVHWXSPLFURSKRQHIURP
WKHXQLW¶V6(7830,&MDFN
16
6HW'\QDPLF9ROXPH
>@
)LQLVK
6WRULQJFRPSOHWH
$XWR6HWXSLVQRZ
ILQLVKHG3OHDVHXQSOXJ
PLFURSKRQH
7XUQRQ'\QDPLF9ROXPH"
$8726(783
$8'<66(<$8726(783
(17(5 ([LW
7XUQ'\QDPLF9ROXPHRQDQGH[LW$XWR6HWXS
<HV 1R
0XOW(4;7
• For details of Dynamic Volume settings, see
page 76.
n When turning Dynamic Volume on
Use o to select “Yes“, and then press ENTER.
• The unit automatically enters “Evening” mode.
n When turning Dynamic Volume off
Use p to select “No“, and then press ENTER.
NOTE
After performing Audyssey Auto Setup, do not
change the speaker connections or subwoofer
volume. In event of a change, perform Audyssey
Auto Setup again.
Remote control operation
buttons
Move the cursor
(Up/Down/Left/Right)
Confirm the setting Return to previous menu
NOTE
• If the result differs from the actual connection
status, or if “Caution!” is displayed, see “Error
messages” (vpage10). Then carry out Audyssey
Auto Setup again.
• If the result still differs from the actual connection
status after remeasurement or the error message
still appears, it is possible that the speakers
are not connected properly. Turn this unit off,
check the speaker connections and repeat the
measurement process from the beginning.
• If you change speaker positions or orientation,
perform Audyssey Auto Setup again to find the
optimal equalizer settings.
11
2Q WKH
STEP3
 VFUHHQ XVH ui
WR VHOHFW ³1H[W 1 &DOFXODWLRQ´ DQG
WKHQSUHVV
ENTER
Measuring results are analyzed, and the
frequency response of each speaker in the
listening room is determined.
>@
$8726(783
$8'<66(<$8726(783
67(3&DOFXODWLRQ
1RZFDOFXODWLQJ
3OHDVHZDLW

0XOW(4;7
• Analysis takes several minutes to complete. The
time required for this analysis depends on the
number of speakers connected.
The more connected speakers there are, the
longer it takes to perform analysis.
STEP 6
Store
Finish

Denon AVR-3311 Specifications

General

Receiver type	Surround
Frequency range	10 - 100000 Hz
Input sensitivity	200 mV
Audio output channels	7.1 channels
Audio A/D Converter (ADC)	24-bit/192kHz
Signal-to-Noise Ratio (SNR)	102 dB
Total Harmonic Distortion (THD)	0.05 %
Power output per channel (1KHz@6 Ohm)	165 W
Power output per channel (20-20KHz@8 Ohm)	125 W
Optical drive included	No
Display	LED
Equalizer	Yes
HDMI version	1.4a
Product color	Silver
Audio decoders	DTS 96/24, DTS-ES (Discrete 6.1), DTS-HD, DTS-HD Master Audio, Dolby Digital EX, Dolby Digital Plus, Dolby Pro Logic II, Dolby Pro Logic IIx, Dolby Pro Logic IIz, Dolby TrueHD
Volume control	Rotary
Multi-Zone quantity	4
Apple docking compatibility	iPod Classic 4, iPod Classic 5, iPod Mini 1, iPod Mini 2, iPod Nano 1, iPod Nano 2
Supported video modes	1080p
HDMI in	6
Audio (L/R) in	9
Composite video in	5
USB ports quantity	1
S-Video inputs quantity	2
Audio formats supported	AAC, FLAC, MP3, WAV, WMA
Image formats supported	JPG
AM band range	522 - 1611 kHz
FM band range	57.5 - 108 MHz
Composite video out	3
Headphone connectivity	3.5 mm/6.35 mm
Digital audio coaxial out	0
AC input voltage	230 V
AC input frequency	50 Hz
Power consumption (standby)	0.1 W
Power consumption (typical)	670 W

Weight and Dimensions

Depth	381 mm
Width	434 mm
Height	171 mm
Weight	12200 g