Denon AVR-3312CI

64
Connect
6.1-channel (Surround back speaker) connection
If using only one surround back speaker (with a 6.1-channel connection), connect to the “L” side of the
SURR. BACK/AMP ASSIGN terminal.
For speaker settings in this case, see “When 6.1ch (Surround back speaker) installed” (vpage62).
To perform 6.1-channel playback using the surround back speaker, set “Amp Assign” to “NORMAL” in
steps 3 and 4 for “Set up “Amp Assign”” (vpage68).
Also use the “Speaker Config.” setting (vpage106) to set “Surr.Back” to “1spkr”.
NOTE
•For speaker cable connections, see C page 6 “Connecting the speakers”.
•For speaker impedance , see page63.
FL FR
C
SB
SL
SR
SW
Basic version
Advanced version
Information
Advanced version