To Next Page

To Previous Page

Set up the

remote control unit

n Set up the zone mode

Press ZONE SELECT to switch the zone mode to

J (MAIN ZONE).

The J indicator lights.

Press ZONE SELECT

n Set up the operation mode

Press AMP to set the remote control unit to AMP-

operation mode.

Press AMP

Connect the setup microphone.

AUDYSSEY AUTO SETUP

1 2 3 4 5 6

Amp Assign

RETURN

Auto Setup Start

Channel Select

STEP1 Preparation

Connect the speakers and place them according

to the recommendations in the manual.

Set the following items

If necessary.

Start Auto Setup

Enter Cancel

When the setup microphone is

connected, the following screen is

displayed.

Set up speakers

around items indicate the settings.

Here we describe how to set up speakers other than 5.1-channel speakers.

For the method of setting up 5.1-channel speakers, see C page 4 “SETUP WIZARD”.

First install and connect the speakers to this unit.

Before Auto Setup measurement, the settings shown below can be made.

•Changing the ampliﬁer assignment (Amp Assign)

The signal output from the SURR.BACK/AMP ASSIGN speaker terminal of this unit can be switched to match your speaker environment (vpage68 “Set up “Amp Assign””).

•Setting the channels to be used (Channel Select)

If channels that are not to be used are set in advance, measurement for the set channels is skipped, and measuring time can be reduced. You can also change the number of surround back speakers (vpage69

“Set up “Channel Select””).

Set up “Amp Assign”

Use ui to select “Amp Assign”, and then press

ENTER.

AMP ASSIGN [1/2]

RETURN

Assign Mode ZONE2

Assign power amp to ZONE2 stereo signal

Return

ZONE2: ZONE3:

AUDYSSEY AUTO SETUP

1 2 3 4 5 6