93
Set up speakers
7
Set up “Channel Select”
Use ui to select “Channel Select”, and then press
ENTER.
Channel Select
Subwoofer Measure
Audyssey Setup
Amp Assign
Channel Select
Start
Your AV receiver can automatically measure the acoustics of
your room then optimize your speakers using the included
microphone.
Set the following items
if necessary.
8
Use ui to select a channel, and then press ENTER.
Front
Select for setting the front speakers to be used. In this
case, go to step 9.
•“Front” can be set when “Assign Mode” is set to
“Front B”.
Subwoofer
Select for no subwoofers to be used. In this case, go
to step 10.
Surround
Back
Select the number of surround back speakers to be
used. In this case, go to step 11.
•“Surround Back” can be set when “Assign Mode” is
set to “Main Only”.
Front
Height
Select for no front height speakers to be used. In this
case, go to step 12.
•“Front Height” can be set when “Assign Mode” is
set to “Main Only”.
Front Wide
Select for no front wide speakers to be used. In this
case, go to step 13.
•“Front Wide” can be set when “Assign Mode” is set
to “Main Only”.
9
Use o p to select a front speaker, and then press
ENTER.
A Select this to use front speaker A.
B
Select this to use front speaker B.
A+B
Select this to use front speakers A and B simultaneously.
5
Use o p to select the
conguration of the connected
speakers, and then press
ENTER.
Main Only
Setting for 7.1-channel playback using surround
back, front height, or front wide speakers.
ZONE2
Setting to assign the unit’s built-in power amplifier
for ZONE2 and output the audio in stereo.
ZONE3
Setting to assign the unit’s built-in power amplifier
for ZONE3 and output the audio in stereo.
Z2/Z3(M)
Setting to assign the unit’s built-in power amplifier
for ZONE2 and ZONE3 and output the audio in
monaural.
Bi-AMP
Setting to use the front speakers via the bi-amp
connection.
Front B
Setting to use the second set of front speakers for
playback.
2CH
Setting to use the other front speakers for playback
when you do 2-channel playback in DIRECT or
STEREO mode.
6
Press o or BACK to exit the “Amp Assign” setting.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
