Denon AVR-4806 - Easy Setup and Operation: Speaker Configuration; Basic Speaker System Layout; Surround Speaker Selector Function

- 14 -
EVENT PARAMETER
function example *RES.
ZM ON MAIN-ZONE ON/OFF change ZMON<CR>
OFF ZMOFF<CR>
Z2 PHONO MULTI ZONE-2 source change Z2PHONO<CR>
| ---The name of PARAMETER is |
CDR/TAPE
the same as that of the time of SI COMMAND.
Z2CDR/TAPE<CR>
SOURCE MULTI ZONE-2 mode cancel Z2SOURCE<CR>
** MULTI ZONE-2 VOLUME change , **:10 to 99 by ASCII Z280<CR>
98 = +18dB(MAX)
80 = 0dB
10 = -70dB
99 = ---(MIN)
ON MULTI ZONE-2 ON/OFF change Z2ON<CR>
OFF Z2OFF<CR>
Z2MU ON
ZONE2 OUTPUT MUTE ON/OFF change
Z2MUON<CR>
OFF Z2MUOFF<CR>
Z3 PHONO
MULTI ZONE-3 source change
Z3PHONO<CR>
|
---The name of PARAMETER is
|
CD/TAPE
the same as that of the time of SI COMMAND.
Z3CDR/TAPE<CR>
SOURCE
MULTI ZONE-3 mode cancel
Z3SOURCE<CR>
**
MULTI ZONE-3 VOLUME change , **:10 to 99 by ASCII
Z380<CR>
98 = +18dB(MAX)
80 = 0dB
10 = -70dB
99 = ---(MIN)
ON
MULTI ZONE-3 ON/OFF change
Z3ON<CR>
OFF Z3OFF<CR>
Z3MU ON
ZONE3 OUTPUT MUTE ON/OFF change
Z3MUON<CR>
OFF Z3MUOFF<CR>
SR PHONO REC SELECT source change SRPHONO<CR>
| ---The name of PARAMETER is |
CD/TAPE
the same as that of the time of SI COMMAND.
SRCDR/TAPE<CR>
SOURCE REC SELECT mode cancel SRSOURCE<CR>
The PARAMETER of Z2, Z3 EVENT : Uses two ASCII characters. (see page4 J) section)