Denon AVR-4810CI - Page 18

18
AVR-4810CI/AVR-4810
1. Version display (µcom/DSP Error Display)
1.1. Operation Spec
µcom version display mode:
When the following conditions are satisfied at its starting state, error information is displayed before version information.
Starting method (same as µcom version display):
Press the ON/OFF button to turn on while pressing both buttons STATUS and RETURN at the same time.
("Error information" is displayed after about 10 seconds.)
The FL display changes in the order given in item-1.2. each time you press the STATUS button.
1.2. Display Order
Error information(Refer to 1.3. Error display) →① Model destination information → ② Main-µcom /Main FLASH
→③ Main1st Boot Loader /Sub-µcom →④ DSP1 /DSP2 →⑤ DSP3 →⑥ Audio FPGA/Video PLD →⑦ GUI FPGA Config
→⑧ GUI Nios Program/GUI Serial Flash →⑨ ETHER(DM870) First BootLoader, HardwareID
→⑩ ETHER(DM870) Second BootLoader, RhapsodyFlag →⑪ ETHER(DM870) IMAGE
→⑫ ETHER(DM870) MAC ADDRESS information →⑬ HD RADIO SDK /HD RADIO DSP
(E3 model only)
→⑭ MultEQ Pro APP (Displayed when Audyssey Pro is complete)
→⑮ MultEQ Pro ICL (Displayed when Audyssey Pro is complete)
No. Display item Display
①
Model destination
Serial No.
②
Main-µcom
MainFLASH
③
Main 1st Boot Loder
Sub-µcom
④
DSP 1
DSP 2
⑤
DSP 3
⑥
Audio FPGA
Video PLD
⑦
GUI FPGA
⑧
GUI Nios
GUI Sflash Font
⑨
DM870 1st Bootloader
- Hard ID
⑩
DM870 2nd Bootloader
- Rhapsody Flag
⑪
DM870 Image
⑫
ETHER MAC ADDRESS
⑬
HD RADIO SDK
HD RADIO DSP
⑭
MultEQ Pro APP
⑮
MultEQ Pro ICL
A
VR4 8 1 0 E3
S
/N. 9041500001
Ma i n : .
Ma i n ROM : .
Ma i n FBL : .
Sub : .
DSP1 : .
DSP2 : .
DSP3 : .
A
ud i o FPGA:
V
ideo PLD :
G
UI Conf ig:
G
UI PRG:
G
UI DAT:
E
ther FBL
-
E
ther SBL
-
E
ther IMG
-
*
Ethernet MAC
-
*
HDSDK : .
*
HDDSP : C0 0 0 2 . 0 0 0
*
Mu l t EQ P r o APP
...
*
Mu l t EQ P r o I CL
...