Denon AVR-5805 - Page 17

29.Mar.06
17/25
COMMAND PARAMETER
function example
Z3 PHONO
MULTI ZONE-3 mode set , and select source
Z3PHONO<CR>
|
---The name of PARAMETER is
|
CDR/TAPE
the same as that of the time of SI COMMAND.
Z3CDR/TAPE<CR>
SOURCE
MULTI ZONE-3 mode cancel
Z3SOURCE<CR>
UP
MULTI ZONE-3 VOLUME UP/DOWN , direct change to ***dB
Z3UP<CR>
DOWN Z3DOWN<CR>
**
**:00 to 99 by ASCII , 80=0dB, 99=---(MIN)
Z380<CR>
ON
MULTI ZONE-3 ON/OFF change
Z3ON<CR>
OFF Z3OFF<CR>
Z3MU ON
ZONE3 OUTPUT MUTE ON/OFF change
Z2MUON<CR>
OFF Z2MUOFF<CR>
Z4 PHONO
MULTI ZONE-4 mode set , and select source
Z4PHONO<CR>
|
---The name of PARAMETER is
|
CDR/TAPE
the same as that of the time of SI COMMAND.
Z4CDR/TAPE<CR>
SOURCE
MULTI ZONE-4 mode cancel
Z4SOURCE<CR>
UP
MULTI ZONE-4 VOLUME UP/DOWN , direct change to ***dB
Z4UP<CR>
DOWN Z4DOWN<CR>
**
**:00 to 99 by ASCII , 80=0dB, 99=---(MIN)
Z480<CR>
ON
MULTI ZONE-4 ON/OFF change
Z4ON<CR>
OFF Z4OFF<CR>
Z4MU ON
ZONE4 OUTPUT MUTE ON/OFF change
Z2MUON<CR>
OFF Z2MUOFF<CR>
SR PHONO REC SELECT mode set , and select source SRPHONO<CR>
| ---The name of PARAMETER is |
CDR/TAPE
the same as that of the time of SI COMMAND.
SRCDR/TAPE<CR>
SOURCE REC SELECT mode cancel SRSOURCE<CR>
Z3, Z4 COMMAND : "*" parameter uses two or three ASCII characters. (see page4 J) section)
The BOLD COMMANDS are new.