EasyManuals Logo

Denon AVR-590 User Manual

Denon AVR-590
74 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #57 background imageLoading...
Page #57 background image

ENGLISH
Getting Started
Connections Playback Remote Control Troubleshooting
SpecificationsSettings
Surround
Button
Note
Input signals
ANALOG
PCM DTS-HD DTS DOLBY DOLBY DIGITAL
Surround mode
Linear
PCM
(multi ch)
Linear
PCM
(2ch)
DTS-HD
Master
Audio
DTS-HD
High
Resolution
Audio
DTS ES
DSCRT
(With Flag)
DTS ES
MTRX
(With Flag)
DTS
(5.1ch)
DTS
96/24
DOLBY
TrueHD
DOLBY
DIGITAL
Plus
DOLBY
DIGITAL
EX (With
Flag)
DOLBY
DIGITAL
EX (With
no Flag)
DOLBY
DIGITAL
(5.1/5/4ch)
DOLBY
DIGITAL
(4/3ch)
DOLBY
DIGITAL
(2ch)
STANDARD
MULTI CH IN
MULTI CH IN
A F A A A A A A A A A A A A A A
MULTI IN + PLgx CINEMA
z
2
z
3
A S A A A A A A A A A A A A A A
MULTI IN + PLgx MUSIC
z
1
z
3
A S A A A A A A A A A A A A A A
MULTI IN + PLgz
z
1
z
5
A S A A A A A A A A A A A A A A
MULTI IN + Dolby EX
z
1
z
3
A S A A A A A A A A A A A A A A
MULTI CH IN 7.1
z
3
A F D (7.1) A A A A A A A A A A A A A A
DIRECT
DIRECT
S A S S S S S S S S S S S S S S
MULTI CH DIRECT
A S A A A A A A A A A A A A A A
M DIRECT + PLgx CINEMA
z
2
z
3
A S A A A A A A A A A A A A A A
M DIRECT + PLgx MUSIC
z
1
z
3
A S A A A A A A A A A A A A A A
M DIRECT + PLgz
z
1
z
5
A S A A A A A A A A A A A A A A
M DIRECT + Dolby EX
z
1
z
3
A S A A A A A A A A A A A A A A
M DIRECT 7.1
z
3
A S (7.1) A A A A A A A A A A A A A A
DSP SIMULATION
5CH/7CH STEREO
z
4
S S S S S S S S S S S S S S S S
ROCK ARENA
S S S S S S S S S S S S S S S S
JAZZ CLUB
S S S S S S S S S S S S S S S S
MONO MOVIE
S S S S S S S S S S S S S S S S
VIDEO GAME
S S S S S S S S S S S S S S S S
MATRIX
S S S S S S S S S S S S S S S S
VIRTUAL
S S S S S S S S S S S S S S S S
STEREO
STEREO
F S F S S S S S S S S S S S S S
NOTE :
z
1: This mode is not available when the surround back speaker setup is set to “None”.
z
2: This mode is not available when the surround back speaker setup is set to “1ch” or “None”.
z
3: Can be set when “Pre Assign” is set to “Normal”.
z
4: If the surround back speaker setup is set to “None”, then “5CH STEREO” is displayed.
z
5: Not selectable when “Pre Assign” is set to anything other than “Front Height”.
F : Mode selectable in initial status
D : Mode fixed when “AFDM” is “ON”
S : Selectable mode
A : Non-selectable mode
Information

Table of Contents

Other manuals for Denon AVR-590

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-590 and is the answer not in the manual?

Denon AVR-590 Specifications

General IconGeneral
Number of Channels5.1
HDMI Inputs3
HDMI Outputs1
Response Bandwidth10 Hz - 100 kHz
Signal-To-Noise Ratio98 dB
THD0.08%
Input Impedance47 kOhm
Input Sensitivity200 mV
Tuner TypeDigital
Tuner BandsAM/FM
Preset Station Qty56
Surround System Class5.1 channel
HDMI SwitchingYes
Width434 mm
Frequency Response10 Hz - 100 kHz
Dolby TechnologiesDolby Digital, Dolby Digital Plus, Dolby Pro Logic II
DTS TechnologiesDTS 96/24, DTS Neo:6
Audio D/A Converter24-bit / 192kHz
Tuner Frequency RangeFM: 87.5-108 MHz, AM: 522-1611 kHz

Related product manuals