58
9
OPERATION
Before operating
1
Refer to “CONNECTIONS” (pages 6 to 13) and check that all
connections are correct.
2
Select “AMP” using the AMP button.
(only when operating with the remote control unit)
3
Press the POWER switch (button).
(Main unit)
(Remote control unit)
• ¢ ON
The power turns on and indicator is light.
Set the power switch to this position to turn the power on
and off from the included remote control unit.
• £ OFF
The power turns off and indicator is off.
In this position, the power cannot be turned on and off
from the remote control unit.
4
Turn on the power
Press the POWER ON/STANDBY switch (button).
(Main unit)
When pressed, the power turns on and the display lights. The sound
is muted for several seconds, after which the unit operates normally.
When pressed again, the power turns off, the standby mode is set
and the display turns off.
(Remote control unit)
5
The front speakers switch as shown below each time the
FRONT SPEAKER button is pressed.
(Main unit)
(Remote control unit)
To Next Page
Loading...
Need help?
General
