Denon AVR-E200 - µcom;DSP;OSD Firmware Version Display; Version Display Mode Operation; Firmware Version Display Sequence; Error Condition and State Mapping

17
1. µcom/DSP/OSDVersiondisplaymode
1.1. Operationspecications
µcom/DSP/OSDversiondisplaymode:
Whenthesetisstartedupinthismode,theversioninformationisdisplayed.
Starting up:
Pressthe
X
buttontoturnonthepowerwhilepressingthe"DIMMER"and"STATUS"buttons.
Now,pressthe"STATUS"buttontothedisplaythe2nditeminformationontheFLDisplay.
1.2. Display Order
q
Modeldestinationinformation→
w
Main-µcomversion→
e
DSPversion→
r
OSDversion
Display State
q
Modeldestinationinformation
AVR-E200E3,E3Bmodel
A V R - E 2 0 0 E 3
AVR-X500E2,E1model
A V R - X 5 0 0 E 2
AVR-X500E1Cmodel
A V R - X 5 0 0 E 1 C
w
Main-µcomversion
M a i n : * * . * *
e
DSPversion
D S P . * . * . *
r
OSDversion
O S D : * * . * *
Cleared of mode:
Pressthe
X
buttontoturnthepoweroff.
1.3. Error display
Seethefollowingtableforeach"Errorinformation"displayanditscontents(status).
Condition - State
DSPNG WhenDSPboot,executingDSPresetmakestobecomeserror.
D S P E R R O R 0 1
DSPOK (Noerrordisplay,versiondisplayonly)