EasyManua.ls Logo

Denon AVR-E200 - ERROR CHECKING AND PROTECTION HISTORY; Error Mode Activation and Operation; FL Display Protection Information

Denon AVR-E200
120 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
18
2. Errors checking mode (Displaying the protection history)
2.1. Operationspecications
Error mode (Displaying the protection history):
Whenthesetisstartedupinthismode,theerrorinformationisdisplayed.
Starting up:
Whenpoweristurnedon,presssingbothbuttons[PRESET+]and[STATUS]atthesametimefor3secondsormore.
Protectionhistorymodeisset.Inthismode,informationshowninthefollowingsectionsisdisplayed.
2.2. About the display on the FL display
InformationaboutthelastProtectionoperationisdisplayed.
(1) Normal(whentherehasbeennoprotectionincident)
FLD
N O P R O T E C T
(2) ForASO(whenthelastprotectionincidentwasASOprotection)
FLD
P R T : A S O
Cause:
Thelinebetweenspeakerterminalsisshorted,orspeakerswithimpedanceoflessthantheratedvalue.
Supplementary information:
Astheexcesscurrentisdetectedafteroperationofthespeakerrelay,ashortonthe
speakerterminalandtheconnectedspeakercanbeidentied.
(3) ForDC(whenthelastprotectionincidentwasDCprotection)
FLD
P R T : D C
Cause:
DCoutputofthepoweramplierisabnormal.
Ifthepoweristurnedonwithoutcorrectingtheabnormality,theprotectionfunctionwillworkabout6secondslater
andthepowersupplywillbeshutoff.
(4) ForTHERMAL(whenthelastprotectionincidentwasTHERMAL(A)orTHERMAL(B)protection)
FLD
P R T : T H E R M A L A
FLD
P R T : T H E R M A L B
Cause:
Thetemperatureoftheheatsinkisexcessive.
Ifthepoweristurnedonwithoutcorrectingtheabnormality,theprotectionfunctionwillworkabout4minuteslater
andthepowersupplywillbeshutoff.
(5)ForPower(whenthelastprotectionincidentwasPowerprotection)
FLD
P R T : P o w e r
Cause:
ThePowerSupply(
±
12V)isabnormal.
b
Additionalcausesofprotectioncanbeduetolooseconnections,associatedcomponents,Microprocessor,etc.
Whenthe"STATUS"buttonispressedagainaftertheaboveprotectionhistoryasshownaboveisdisplayed,thenormal
displayreappears.

Table of Contents

Other manuals for Denon AVR-E200

Related product manuals