Audyssey
Set Audyssey MultEQ
®
XT, Audyssey Dynamic EQ
®
and Audyssey
Dynamic Volume
®
. These can be selected after Audyssey
®
Setup has
been performed.
For additional information on Audyssey technology, please see
“Explanation of terms” (v
p. 221).
0
“MultEQ
®
XT”, “Dynamic EQ” and “Dynamic Volume” settings are stored for each
input source.
0
When the sound mode is in the “Direct” mode, “MultEQ
®
XT”, “Dynamic EQ” and
“Dynamic Volume” settings cannot be configured.
o
MultEQ
®
XT
MultEQ
®
XT compensates for both time and frequency characteristics
of the listening area based on Audyssey
®
Setup measurement results.
Selection is done from three types of compensation curves. We
recommend the “Reference” setting.
Reference
(Default):
Selects the default calibrated setting with
a slight roll off at high frequencies, which
is optimized for movies.
L/R Bypass:
Selects the reference setting, but
bypasses MultEQ
®
XT on the front left
and right speakers.
Flat:
Selects the calibrated setting which is
optimized for small rooms where your
listening position is closer to the
speakers.
Off :
Do not use “MultEQ
®
XT”.
When using headphones, “MultEQ
®
XT” is automatically set to “Off”.
Contents Connections Playback Settings Tips Appendix
141
Front panel Display Rear panel Remote Index
To Next Page
Loading...
