13
When the analysis and storage ends, unplug the Sound
calibration microphone from the SETUP MIC jack on the
main unit and then press “Next”.
.
Audyssey Setup
Analyzing room data
Back Next
Now Analyzing and correcting the your room data.
14
Select “Details” and press ENTER to verify the
measurement results.
0
Subwoofers may measure a greater reported distance than the
actual distance due to added electrical delay common in
subwoofers.
NOTE
Do not change the speaker connection or subwoofer volume after Audyssey
®
Setup.
If these are changed, run Audyssey
®
Setup again in order to configure the optimum
equalizer settings.
Contents Connections Playback Settings Tips Appendix
160
Front panel Display Rear panel Remote Index
To Next Page
Loading...
