EasyManuals Logo

Denon AVR-X7200W Product Guide

Denon AVR-X7200W
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
 FM/AM antenna terminals (ANTENNA)
Used to connect FM antennas and AM loop antennas.
 TRIGGER OUT jacks
Used to connect devices equipped with the trigger function. 1@
REMOTE CONTROL jacks
Used to connect infrared receivers/transmitters in order to
operate this unit and external devices from a different room.
 RS-232C connector
Used to connect home automation controller devices fitted with
RS-232C connectors. Consult the owner’s manual of the home
automation controller for more information about serial control of
this unit.
Perform the operation below beforehand.
Turn on the power of this unit.
Turn off the power of this unit from the external controller.
Check that the unit is in the standby mode.
 Digital audio connectors (DIGITAL AUDIO)
Used to connect devices equipped with digital audio connectors.
 Speaker terminals (SPEAKERS)
Used to connect speakers.
 PRE OUT connectors
Used to connect a subwoofer with built-in amplifier or an external power
amplifier.
 Video connectors (VIDEO)
Used to connect devices equipped with video connectors.
 Component video connectors (COMPONENT VIDEO)
Used to connect devices equipped with component video connectors.
HOME
Rear Panel (2 of 2)
REMOTE CONTROL 1REAR PANEL 1
7

Other manuals for Denon AVR-X7200W

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-X7200W and is the answer not in the manual?

Denon AVR-X7200W Specifications

General IconGeneral
Receiver typeSurround
Input sensitivity200 mV
Audio output channels11.2 channels
Signal-to-Noise Ratio (SNR)102 dB
Power output per channel (1KHz@6 Ohm)190 W
Power output per channel (20-20KHz@8 Ohm)210 W
HDMI in8
Audio (L/R) in7
Composite video in5
Digital audio optical in2
Ethernet LAN (RJ-45) ports1
Component video (YPbPr/YCbCr) in3
12V triggerYes
Speakers connectivity type-
AM band range522 - 1611 kHz
FM band range87.5 - 108 MHz
Supported radio bandsAM, FM
Optical drive includedNo
DisplayLCD
Product colorBlack
Audio decodersDolby TrueHD, DTS 96/24, DTS-ES, DTS-HD Master Audio
AC input voltage230 V
AC input frequency50 Hz
Power consumption (standby)0.1 W
Power consumption (typical)780 W
Weight and Dimensions IconWeight and Dimensions
Depth427 mm
Width434 mm
Height196 mm
Weight17800 g

Related product manuals