Denon DCD-50 - Troubleshooting; Power does not turn on; Power is turned off; LED is flashing

Troubleshooting
If a problem should arise, first check the following.
1. Are the connections correct?
2. Is the set being operated as described in the owner’s manual?
3. Are the other devices operating properly?
If this unit does not operate properly, check the items listed in the table below.
Should the problem persist, there may be a malfunction. In this case, disconnect the power immediately and contact your store of purchase.
o
Power does not turn on / Power is turned off
Symptom Cause / Solution Page
Power is not turned on.
0
Check whether the power plug is correctly inserted into the power outlet. 21
Power automatically turns
off.
0
The Auto Standby mode is set. The Auto Standby mode switches the unit to standby mode when the unit
is not operated for approximately 30 minutes. To disable the Auto Standby mode, press and hold the
power operation button (X) for more than 5 seconds when the Auto Standby mode is enabled.
30
o
LED is flashing
Symptom Cause / Solution Page
Flashing red.
0
A circuit in the unit has malfunctioned. Disconnect the power and contact the repair center. －
Contents Connections Playback Settings Tips Appendix
34
Front panel Display Rear panel Remote Index