15
To create a Program (a list of tracks that will play in a specific order):
1. Press Prog on the remote control. The Program page will appear on the screen.
In the Program page, the type of media and total number of tracks (Track Total) will appear above the
15 available slots of the Program.
2. Do any of the following in the Program page:
• At any time, press Play (
) on DN-500BD or the remote control to start playing the Program.
• At any time, press Return on the remote control to exit the Program page. This will clear all slots of
the Program.
• Press OK on the remote control to “unlock” the current slot of the Program (outlined in yellow). Use
the up/down cursor buttons () or number buttons (0–9) to enter the desired track, and then
press OK to confirm your choice.
• If the current slot of the Program (outlined in yellow) contains a track number, press Clear on the
remote control to clear that slot.
While viewing the Program page, you cannot use any buttons (on DN-500BD or the remote control)
other than the ones described above.
To Next Page
Loading...
