Denon DN-501C

APPENDIX
Appendix
Appendix shows the list of commands that control this unit externally through a host device.
Normally, it is dealers such as installers that use the list of commands to make settings, so this section is only in English.
n Extended Communication Format (MIDI)
Control Command List
Category Command
Command code
Parameter 1 Parameter 2 Remarks
Category code
Command
number
Playback operation STOP 0 1 - - Command example) F0 00 40 03 11 01 00 00 01 00 31 33 F7
PLAY 0 2 - - Command example) F0 00 40 03 11 01 00 00 02 00 31 34 F7
PAUSE 0 3 - - -
CUE 0 4 - - -
CUE TRK XXXX 0 5 Number - Track No. 2 bytes specification (DN501C extended to 4 bytes)
CUE TIM XXXX 0 6 TIME STRING. - TIME STRING specified
FRAME FWD 0 7 - - -
FRAME REV 0 8 - - -
SEARCH SS1 FWD 0 10 - - -
SEARCH SS1 REV 0 11 - - -
SEARCH SS2 FWD 0 12 - - -
SEARCH SS2 REV 0 13 - - -
SEARCH SS3 FWD 0 14 - - -
SEARCH SS3 REV 0 15 - - -
SEARCH SS4 FWD 0 16 - - -
SEARCH SS4 REV 0 17 - - -
SEARCH SS5 FWD 0 18 - - -
SEARCH SS5 REV 0 19 - - -
TRACK FWD 0 20 - - -
TRACK REV 0 21 - - -
HOT START XXXX 0 22 Number - Hot No. 1 byte specification (1 - 20)
HOT CUE XXXX 0 23 Number - Hot No. 1 byte specification (1 - 20)
SKIP BACK 0 24 - - -
FRAME ON 0 25 Number - ON:1/OFF:0
END MONITOR 0 26 - - -
Device operation POWER ON 1 1 - - -
POWER STDBY 1 2 - - -
RETRACT 1 3 - - -
EJECT 1 4 - - -
UNBAL VOL UP 1 5 Number -
Volume Up Step Up Count 1 byte received side is interpreted as Count value x
volume minimum step (dB) Up.
UNBAL VOL DN 1 6 Number -
Volume Down Step Count 1 byte received side is interpreted as Count value x
volume minimum step (dB) Down.
UNBAL VOL XXXX 1 7 Number -
Volume Value 4bytes specification Byte1 symbol =0:positive/1:negative
Byte2 Volume(db) ten value (0 - 9) Byte3 Volume(db) single value (0 - 9) Byte4
Volume(db) first decimal value (0 - 9) Byte5 Volume(db) first decimal value (0 - 9)
ENTER 1 8 - - -
ESC 1 9 - - -
ABORT 1 10 - - -
ARROW D 1 11 - - -
ARROW U 1 12 - - -
ARROW R 1 13 - - -
ARROW L 1 14 - - -