Denon DN-700C

DN-700C/DN-501C
MIDI Command Guide
23
Command
Category
Code
Command Example Example Command Code * Red points are variable Remark
[GET PRG NO] 9 28 Get Program number 0xF0,0x00,0x40,0x03,0x11,0x01,0x00,0x09,0x1C,0x00,0x33,0x37,0xF7
[GET PRG FILE] 9 29 Get program file name 0xF0,0x00,0x40,0x03,0x11,0x01,0x00,0x09,0x1D,0x00,0x33,0x38,0xF7
[GET PRG FILE XXX] 9 30 Get file name of program #0001
0xF0,0x00,0x40,0x03,0x11,0x01,0x00,0x09,0x1E,0x04,0x30,0x30,0x30,0x31,0x46,
0x45,0xF7
* 1
Get file name of program #0002
0xF0,0x00,0x40,0x03,0x11,0x01,0x00,0x09,0x1E,0x04,0x30,0x30,0x30,0x32,0x46,
0x46,0xF7
[GET PRG TTL] 9 31 Get total Number of program 0xF0,0x00,0x40,0x03,0x11,0x01,0x00,0x09,0x1F,0x00,0x33,0x41,0xF7
[GET TRP DIR] 9 33 Get playback direction 0xF0,0x00,0x40,0x03,0x11,0x01,0x00,0x09,0x21,0x00,0x33,0x43,0xF7
[GET TRP SPD] 9 34 Get playback speed 0xF0,0x00,0x40,0x03,0x11,0x01,0x00,0x09,0x22,0x00,0x33,0x44,0xF7
* 1 The parameter and checksum (written in red) are variable. The first 4 bytes are the file number (“0000” to “2000” in ASCII).