Denon DN-700C

DN-700C/DN-501C
MIDI Command Guide
4
2. Specification
2-1. RS-232C Control
The host can control the device when they are connected with a RS-232C straight cable. Connect the cable to the device's 9-pin D-sub connector
as shown in the following diagram.
• Transmission type： Asynchronous / full duplex
• Connector type： 9-pin D-sub (straight)
• Transfer rate： 9,600 / 38,400 bps, selectable (via “Serial Bit Rate” in the “System Setting” menu)
• Clock accuracy： < +2.0%
• Data length： 8 bits
• Parity： None
• Start bit： 1 bit
• Stop bit： 1 bit
• Flow Control： None
• Maximum data length： 93 bytes