DN-700C/DN-501C
MIDI Command Guide
3
1. General
Note: In this document, the controlled equipment is called the “device” (our product) and the controlling equipment is called the “host”.
The Serial Remote control function can be used when the host machine, like a PC, is connected to the device. The host controls the device by
sending Control commands and detects the device's status by sending Status Request commands. The device and host can be connected in one
of two ways: RS-232C and IP (Ethernet).
Three main features:
1. Device control from the host
2. Device status detection via Status Request commands from the host
3. Device status changes are sent automatically to the host
To Next Page
Loading...
