10
DN-HD2500
2.7
TOUCH_Init
mode
Turn the Deck1 or Deck2 PARAMETERS knob
to select "TOUCH_Init" from the FUNCTION
check mode's top menu, then press the
PARAMETERS knob to set "TOUCH_Init"
mode.
The detection level value and detection thresh-
old value stored in the EPROM in the touch
sensor's IC are rewritten with the factory
default values and the touch sensor IC is ini-
tialized.
When the process has completed normally,
"Complete!!" is displayed.
UP, R, DOWN and L display section
Displays the touch detection counter value
when the power is turned on.
Judge (70 300) display section
"OK" is displayed if the touch detection
counter value when not being touched is
between 70 and 300. If not, "NG" [No Good] is
displayed.
Step1 display section
Displays the progress of the touch sensor IC's
initialization process.
1) Complete DECK1 Init
Indicates that reading of the touch detection
counter value when the Deck1 JOG disc is
not being touched is completed.
2) Complete DECK2 Init
Indicates that reading of the touch detection
counter value when the Deck2 JOG disc is
not being touched is completed.
3) Complete DECK1 Teaching
Indicates that "verify check" of the Deck1
touch detection system data (detection level
value and detection threshold value) is com-
pleted.
4) Complete DECK2 Teaching
Indicates that "verify check" of the Deck2
touch detection system data (detection level
value and detection threshold value) is com-
pleted.
5) DECK1 EEPROM Complete
Indicates that writing of the "verify check"
data for the Deck1 touch detection system is
completed.
6) DECK2 EEPROM Complete
Indicates that writing of the "verify check"
data for the Deck2 touch detection system is
completed.
When the process has completed abnormally,
"NG" [No Good] and "Fail (Check Touch
Device)" are displayed.
The touch device of the deck concerned, the
chip parts around the touch device and the
touch sensor unit of the side concerned must be
checked.
No Mode Operation and Function Display
No モード 操 作 と 機 能 表 示
To Next Page
Loading...
