Denon DR-M33HX - SPECIFICATIONS; WARNING; Leakage current

SPECIFICATIONS
Type .
Heads .
Motors
Tape Speed.
Fast forward, rewind time.
Recording bias.
Ocerail S/N ratio .
{at 3% THD level)
Overall frequency response.
Channel separation.
Crosstalk.
Wow & flutter.
Inputs
Line.
Outputs
Line.
Headphone.
Accessories.
Power supply.
Power consumption .
Dimensions.
Weight.
Vertical tape loading 4-track 2-channel st er-pw f 3 ;-rttr tape deck
SF Record/Playback combination head x 1
Erase head (Ferrite) x 1
FG Servo Direct Drive motor (for capstan) x 1 (DR-M44HX)
Electronic servo DC motor (for capstan) x 1 (DR-M33HX)
5-pole DC motor (for reel winding ) x 1
4.8 cm/sec.
Approx. 80 sec. with a C-60 cassette
Approx. 105 KHz
Dolby C NR on ... 75 dB (CCIR/ARM)
25 ~ 20,000 Hz ±3dB (at -20 dB METAL TAPE)
more than 40 dB (at 1 KHz)
more than 65 dB (at 1 KHz)
0.035% w.rms (DR-M44HX)
0.04%w.rms (PR-M33HX)
77.5 mV (—20dB) input level at maximum
Input impedance: 50 Kohm unbalanced
775 mV (0 dB) output level at maximum (with 47 Kohm load,
recorded level of 200 pwb/mm)
1.2 mW output level at maximum (optimum load impedance 8 ohm
~ 1.2 Kohm)
parallel pin cord x 2
50/60 Hz compatible, voltage is shown on rating label
25W (DR-M44HX), 24W (DR-M33HX)
434 (W) X 115 (H) X 286 (D) mm (DR-M33HX)
464 (W) X 115 (H) X 286 (D) mm (DR-M44HX)
5.6 kg (DR-M33HX)
6.3 kg (DR-M44HX)
• Above specification and design styling are subject to change without notice for improvement.
Dolby noise reduction and HX PRO headroom extension manufactured under license from Dolby
Laboratories Licensing Corporation. HX PRO originated by Bang and Olufsen. "Dolby”, the double-
D symbol, and "HX PRO" are trademarks of Dolby Laboratories Licensing Corporation.
WARNING:
1. Component parts
Parts marked with ^ and/or shading in this service manual have special characteristics important to
safety. Besure to use the specified parts for replacement.
2. Leakage current
Before returning the appliance to customer, test the leakage current when the power plug is connected.
Use a calibrated (with an error of not more than 5%) leakage current tester and measure the leakage
current from any exposed metal to the earth ground. Reverse the power plug polarity and test the
above again.
Any current measured MUST NOT EXCEED 0.5 milliamps. Corrective measure must be taken if it
exceeds the limit.
- 3 -