Denon DRA-335R - Display Indicators and Tuning Functions

e @
BAND (Band selector switch)
Press this switch to select the FM or AM (MW) band.
TUNING (Tuning buttons)
Press these buttons to tune in a station. In the MANUAL
TUNING mode, each press of the buttons will change the
frequency in 50 kHz steps on FM and 9 kHz steps on AM.
Keeping one of these buttons pressed, the frequency wiil
change until the button is released.
During the AUTO TUNING mode, pressing one of these
buttons will affect station search up or down the band.
TUNING MODE (Tuning mode switch)
This switch allows selection between Auto Tuning and
Manual Tuning.
AUTO TUNING: Pressing the UP button, the tuner will
begin tuning to a higher frequency and pressing the DOWN
button, it will begin tuning to a lower frequency until a
broadcasting station is found.
MANUAL TUNING: Stations are tuned in manually by use
of the UP and DOWN buttons.
DISPLAY
@ @
MW TIP CITT kHz
FM CITC I Maz
SIGNAL (Signal indicator)
This lights when a station is received.
STEREO /MONO (Stereo/Mono indicator)
The STEREO indicator will automatically light up when a
stereo broadcast is received. The MONO indicator will light
up when a broadcast is not being received or at the time of
a monaural broadcast.
TUNING MODE (AUTO/MANUAL)
Pressing TUNING MODE ® causes AUTO and MANU to
light up alternately.
SHIFT (Shift indicator)
The preset channel which is selected with the Shift Button
@ is displayed by the SHIFT [A] or [B] or [A] BB).
©
ENGLISH
e Tape selector (Tape selector switches) (DRA-
435R)
TAPE-1: Press to Select the tape deck con-
nected to the TAPE-1 terminals as the
source.
TAPE-2/VCR: Press to select the tape deck con-
nected to the TAPE-2 terminals as the
source and Press for _ recording/
playback of a Video component con-
nected to these terminals.
e TAPE (Tape monitor switch) (DRA-335R)
Press this switch (ON) to play TAPE and release (OFF) to
play the source selected by the Input selector @.
MEMORY (Memory button)
This switch is used to store the desired radio station on a
PRESET CHANNEL button. When pressing this button, the
MEMORY indicator lights for approximately 5 seconds.
During this interval, the desired station can be stored in the
memory.
PRESET CHANNEL 1 ~ 24 (Preset Station Buttons)
These buttons are used for storing stations or recalling
stations which have been preset. Using the SHIFT button
you can preset a total of 24 FM or AM stations into preset
channels 1 ~ 8, 9 ~ 16 and 17 ~ 24.
Once a radio has been memorized on a PRESET CHANNEL
button, the same station can later be tuned in instantly
simply by pressing the corresponding PRESET CHANNEL
button.
CHI [—
1 (7 MEmMo
@
®
REMOTE SENSOR
MEMORY (Memory indicator)
This indicator lights for approximately 5 seconds when the
MEMORY button has been pressed and a station can be
stored on a PRESET CHANNEL button.
CHANNEL (Preset channel display)
When using the channel preset button @, the channel is
displayed and the frequency for that channel stored in
memory is displayed in @.
Frequency display (Frequency indicator)
The frequency is displayed in numerals. It is displayed in
MHz for FM and in kHz for AM (MW).