Denon DRA-335R - Antenna Setup and System Connections

ENGLISH
ANTENNA INSTALLATION
e FM ANTENNA
The supplied T-type indoor FM antenna (300 ohms) can be
used inside wooden houses for receiving local FM stations
and other strong FM signals. Stretch out the ends of the
antenna and mount the antenna on the wall or ceiling where
optimum reception is achieved. FM T-type antennas may not
consistently ensure stable reception, due to environment
changes. In such cases, the FM T-type antenna should only
be used temporarily until an outdoor FM antenna has been
installed.
When connecting an outdoor FM antenna, the use of 75 ohm
coaxial cable (3C-2V, 5C-2V) is strongly recommended. Using
a 300-ohm feeder cable will cause noise and you will not be
able to achieve the high sound quality the built-in tuner is
capable of delivering.
AM ANTENNA
Attach the supplied AM loop antenna to the antenna holder
on the back panel.
Connect the leads to the AM and GND terminals.
Also use the AM terminals for connecting an outdoor AM
antenna (when making such a connection do not disconnect
the AM loop antenna.)
Adjust the loop antenna to obtain optimum reception. Where
broadcast stations are distant and only weak signals are
received, or where signals are blocked, it is best to install an
outdoor AM antenna.
NOTES
e This receiver has a full back-up system. When the power is
turned on, the INPUT SELECTOR buttons are set to the last
mode set before the power was turned off.
When using this receiver in close proximity to video
equipment (TV, VCR, VDP, etc.), noise may be generated in
AM broadcasts. To avoid this, keep the receiver as far away
from other video components as possible, or detach the AM
loop antenna from the antenna holder and place it where
noise is reduced. if the noise is not reduced, turn off the
power of the video components when listening to AM
broadcasts.