Denon DRA-335R - Remote Control Operation

ENGLISH
CONNECTIONS
FM OUTDOOR ANTENNA
300 ohm TV Receiver/Monitor
ANTENNA {with VIDEO INPUT jack)
FM
INDOOR
ANTENNA
75
ohm
i
a.
TAPE
DECK
2
(An Accessory) ANTENNA CD player VCR-1 (Video Cassette Recorder) =
300 ohm COAXIAL — | OQ = oe
FEEDER | capie ~~~ _[eeeceeeceectrctect & (e=ee +00] ° 200
VCR-2 (Video
FM ANT
ADAPTER
(An Accessory} Se
78 ohm COAXIAL
CABLE
Cassette Recorder
Speaker (A)
Speaker (B)
DENON woo wo ORA-436R
WARNING.
avis
REC
PB
GND
3.5 mm
Attach to the AM OUTDOOR MINI JACK
vy) holder , ANTENNA M cy =
= = ome ©
° —o- ooo
NA 7 TAPE DECK 1
TURNTABLE ®O
zi
SPEAKER
CONNECTION
1.
Peel
off
the
sheathing
from
the
ms
Confirm polarity (+, —) and left and right chan- end of the cord. es)
nels (L, R). Connect the speaker pairs to the
SPEAKER terminals A or B on the back panel.
Connections must be made with power cord
disconnected.
WN
minals.
Twist the wire strands.
Loosen the speaker terminal, in-
sert the wire lead portion of the
code, and then tighten the ter-
Notes on Connection
@ Do not plug the power cord into the AC wall outlet
until all connections have been completed.
e Make sure channels are correctly connected. Connect
Left channels to Left channels and Right channels to
Right channels. Follow the color markings of plugs
and terminals to make sure mistakes are not made.
e Connect all pin-plugs securely, pushing them complet-
ly into the jacks. Incomplete connections will cause
Notes:
e Do not connect two FM antennas simultaneously.
e Even if an external AM antenna is used, de not
disconnect the AM loop antenna.
e Make sure AM loop antenna lead terminals do not
touch metal parts of the panel.
CAUTION
noise generation.
e Binding the connection cables to power cords, or
running such cables close to power supply transfor-
mers will cause humming or noise, and should thus be
avoided.
Protective Circuit
This set is equipped with a high speed protective circuit.
This circuit protects the internal circuitry from damaye due
to large currents flowing when the speaker jacks ae not
completely connected or when an output is generatecd by a
short circuit.
This protective circuit's operation cuts off the outpuito the
speakers. In such a case, be sure to turn the powerto the
set off and check the connections to the speakers. Then
turn the power on again. After muting for several sesonds,
the set will operate normally. |