Denon DRA-335R - Product Overview and Operation; Front Panel Controls and Features

ENGLISH
NAME AND FUNCTION OF PARTS
| ee yeapeom reyes
DRA-435R only
FRONT PANEL
DENON precision aunio COMPONENT / AM-EM STEREO RECEIVER DRA-435R
COMPUTED MULTI FUNGTION DISPLAY SYSTEM
Mw TIVE kee CHET
FM 1 CIE Maz 17] MEMO | REMOTE SENSOR
SIGNAL] STEREO MONO AUTO MANU SHIFT AB
a= ON/STANDBY
POWER (Power switch)
When the power cord is plugged into an AC power outlet,
pressing this button once, the power is turned on and the
DISPLAY lights. It takes a few seconds before sound is
output, thanks to the built-in muting circuit, preventing
audio output until the receiver has stabilized.
PHONES (Headphones jack)
Connect a pair of headphones (sold separately) to this jack
for private listening.
SPEAKERS (Speaker selector switches)
These switches are used to engage speaker system A and
B,
No sound is heard through the speakers when both
switches are reset to the m position.
REMOTE SENSOR (Remote control sensor)
This sensor receives the infra-red light transmitted from the
wireless remote control unit.
For remote control, point the wireless remote control unit
towards the sensor.
BASS (Bass control)
Use this control to adjust the low-range response.
When the control is set to the center position, the frequency
characteristic curve (below 1,000 Hz) is flat. Turn the control
clockwise to increase the bass response and counter-
clockwise to decrease it.
TREBLE (Treble control)
Use this control to adjust the high-range response.
When the control is set to the center position, the frequency
characteristic curve (above 1,000 Hz) is flat. Turn the control
clockwise to increase the treble response and counter-
clockwise to decrease it.
BALANCE (Balance control)
Use this control to balance the volume levels between left
and right channels. The volume levels in both channels are
equal when the control is set to the center position.
DRA-435R only
VARIABLE LOUDNESS (Loudness control)
At low volumes, the human ear is less sensitive to low
(BASS) and high (TREBLE) frequencies. Use this control to
compensate for this deficiency when listening at low
volume levels. Turn this control counter-clockwise until a
natural balance of bass and treble sound has been
restored.
BASS EQ (DRA-435R only)
Press this button to switch the BASS EQ ON (-) for
emphasis of bass sounds.
Use in conjunction with the bass adjustment of the tone
controi will provide further emphasis of bass sounds. Set
this switch to OFF ( ) when you wish to listen with a
normal setting condition.
VOLUME (Volume control)
This knob is used to adjust the volume level of both
channels.
Turn the knob clockwise to raise the volume and counter-
clockwise to lower it.
SHIFT (Shift button)
Each time this button is pressed, the preset station range
will be shifted among “1 ~ 8”, “9 ~ 16” and “17 ~ 24”. (A:
1 ~ 8, B: 9 ~ 16, AB: 17 ~ 24)
Input selector (Input selector buttons)
These buttons are used to select the audio input source.
e PHONO: Press to play a record on a record player
connected to the PHONO input jacks.
e CD: Press to listen to a compact dis: player or
another component connected to te CD input
jacks.
e TUNER: Press to listen to FM or AM proagsams.
e VIDEO: Use when playing back the audio rom a Hi-Fi
video, video disc player or other component
connected to the VIDEO termina:
* If a function switch is pressed quickly, the fun ction may
not actually change and no signal may beh eard from
the speakers for an instant. To avoid this,e sure to
press function switches carefully.