EasyManua.ls Logo

Denon DRA-395 - Safety Precautions; Leakage Current Check; Specifications; Audio Section Specifications

Denon DRA-395
125 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2
DRA-395
SPECIFICATIONS
Audio Section
(Power Amplifier)
Rated output: 80W + 80W (8/ohms, 20Hz ~ 20kHz with 0.08% T.H.D.)
Output terminals: A or B 4 to 16/ohms
A + B 8 to 16/ohms
(Analog)
LINE input - PRE OUT
Input sensitivity/input impedance: 200mV/47k/kohms
Frequency response: 10Hz ~ 50kHz: ±1.5dB
S/N ratio: 100 dB (IHF-A weighted)
Total harmonic distortion: 0.009% (3dB at rated output, 8/ohms) (1kHz)
Rated output: 1.2V
PHONO input - REC OUT
Input sensitivity/input impedance: 2.5mV/47k/kohms
RIAA deviation: ±0.5dB (20Hz ~ 20kHz)
S/N ratio: 74dB (IHF-A weighted, with 5mV input)
Total harmonic distortion: 0.03% (1kHz, 3V)
Rated output/Maximum output: 150mV/7V
Video Section
(Standard Video Jacks)
Input/output level and impedance: 1V p-p, 75/ohms
Frequency response: 5Hz ~ 10MHz +1, 3dB
Tuner Section
[FM] (note: µV at 75/ohms, 0dBf = 1×10
-15
W) [AM]
Receiving range: 87.50MHz ~ 107.90 MHz 520kHz ~ 1710kHz
Usable sensitivity: 1.4µV (14.2dBf) 18µV
50dB quieting sensitivity: MONO 2.8µV (20.2dBf)
STEREO 23µV (38.5dBf)
S/N ratio: MONO 80dB (IHF-A weighted)
STEREO 75dB (IHF-A weighted)
Total harmonic distortion: MONO 0.15% (1kHz)
STEREO 0.3% (1kHz)
General
Power supply: AC120V, 60Hz
Power consumption: 3.39A
Maximum external dimensions: 434 (W) × 147 (H) × 417 (D) mm (17-1/16 × 5-25/32 × 16-7/16)
Weight: 9.7kg (21lbs 6oz)
Remote Control Unit (RC-894)
Batteries: R03/AAA Type (two batteries)
External dimensions: 64 (W) × 206 (H) × 19 (D) mm (2-13/64 × 8-9/32 × 3/4)
Weight: 140g (Approx. 4.9 oz) (including batteries)
* For purposes of improvement, specifications and design are subject to change without notice.
SAFETY PRECAUTIONS
The following check should be performed for the continued protection of the customer and service technician.
LEAKAGE CURRENT CHECK
Before returning the unit to the customer, make sure you make either (1) a leakage current check or (2) a line to chassis
resistance check. If the leakage current exceeds 0.5 milliamps, or if the resistance from chassis to either side of the
power cord is less than 460 kohms, the unit is defective.
w
w
w
.
x
i
a
o
y
u
1
6
3
.
c
o
m
Q
Q
3
7
6
3
1
5
1
5
0
9
9
2
8
9
4
2
9
8
T
E
L
1
3
9
4
2
2
9
6
5
1
3
9
9
2
8
9
4
2
9
8
0
5
1
5
1
3
6
7
3
Q
Q
TEL 13942296513 QQ 376315150 892498299
TEL 13942296513 QQ 376315150 892498299
http://www.xiaoyu163.com
http://www.xiaoyu163.com

Other manuals for Denon DRA-395

Related product manuals