To Next PageTo Next PageWhat to do if the playable disc is not read on Denon DVD-A1UDCI Media Player?
If your Denon Media Player isn't reading a playable disc, the pickup lens may be dirty. Before requesting servicing, try cleaning the laser pickup with a commercially available lens cleaner.
How to enable HD Audio Output on Denon DVD-A1UDCI?
To output HD audio, set “BD Audio Mode” to “HD Audio Output”.
Why does my Denon Media Player get operated by remote control of other DENON products?
To prevent your Denon Media Player from being operated by other Denon product remotes, set “Other Setup” – “Remote Control Setting” – “Receive Legacy Remocon” to “Off” on the GUI menu.
What to do if my Denon Media Player is operated by the remote control of other DENON products?
To prevent the unit from being operated by the remote control of other DENON products, set “Other Setup” – “Remote Control Setting” – “Receive Legacy Remocon” to “Off” on the GUI menu.
What to do if Denon Media Player buttons do not work?
If the buttons do not work or the unit stops responding, the safety protection device may be activated. Unplug the power cord, wait 5-10 seconds, and then plug it in again. Operations may not be permitted by the disc. Refer to the instructions of the disc.
What to do if the password for rating level has been forgotten on Denon DVD-A1UDCI?
On the GUI menu, perform the “Other Setup” – “Initialize” procedure.
Why is there no sound or the sound is hard to hear on Denon DVD-A1UDCI Media Player?
If you're experiencing no sound or the sound is hard to hear on your Denon Media Player: * Check the devices whose audio is connected and the speaker connections. * Verify that the power of the connected devices is on and that the input selection is set to the input to which the DVD-A1UDCI is connected. * Ensure the audio output is properly selected.
How to fix Denon DVD-A1UDCI remote control when it does not work?
If the remote control is not operating your Denon unit: * Aim the remote control directly at the infrared sensor window on the front of the unit. * Ensure you are within 7 meters of the remote control sensor. * Remove any obstacles between the remote and the unit. * Replace the batteries with new ones, inserting them in the correct direction, checking the q and w marks. * Make sure the signal code of the remote control matches the signal code of the unit.
Why does my Denon DVD-A1UDCI freeze momentarily during playback?
If your Denon Media Player's picture freezes momentarily during playback: * The disc may be scratched or contaminated with fingerprints, which can disrupt playback. Clean the disc or replace it with a non-scratched one. * There might be an issue with the data recorded on the disc.
What to do if picture does not appear on Denon DVD-A1UDCI?
If the picture does not appear on your Denon Media Player, try the following: * Switch the TV's input setting to the external input connected to the player. * If the Pure Direct function is set to “On”, set it to “Off”. * Check if “Pure Direct Setup” – “Video Out” on the GUI menu is set to “Off” at the “User Preset 1” or “User Preset 2” setting, and if so, set it to “On”. * Check the connection of the video/S-Video/component video cable. * Ensure the “Video Setup” – “Component Resolution” setting on the GUI menu matches the connected device's resolution.
General| Brand | Denon |
|---|---|
| Model | DVD-A1UDCI |
| Category | Media Player |
| Language | English |
