2. Updating by USB
The latest rmware can be downloaded to a USB memory for updates.
2.1. Connecting to the USB Memory
(1) Preparation
• USB format: Prepare a USB memory formatted in FAT32.
• Do not run the USB memory through a hub.
• Do not connect a computer to the USB port of this unit using a USB cable.
• Do not use an extension cable when connecting the USB unit.
2.2. Download and update the Firmware.
1. Download the HEOS Player’s rmware from SDI.
2. Save the rmware le to the PC.
3. Copy the rmware to USB memory.
4. Connect the USB memory to the HEOS Player’s USB Port.
5. Updating is started automatically.
6. Player’s status LED should be blinking amber during upgrading the rmware.
Exsample of HEOS Link LED Actions.
LED on the front is blinking amber.
7. One the upgrade is complete, the player reboots automatically.
Exsample of HEOS Link LED Actions.
LED on the front is blinking blue.
8. Ready-Congured and connected to your network.
Exsample of HEOS Link LED Actions.
9. Be sure to rewrite the service region setting.
See 21 page "Service region settings update procedures".
--- Precautions for Updates ---
• Never remove the USB memory before the update is nished.
• Never turn off the power before an update is completed.
Once an update is started, normal operations cannot be performed until it is completed.
(blink)
(off)
(blink)
(off)
(solid)
(off)
20
To Next Page
Loading...
