Denon HEOS Amp - Service Release Type Settings Update Procedures

4. Service Release Type settings update procedures
Write the Service Release Type setting le to this unit from the USB memory.
4.1. Items to Be Prepared
・
Windows PC
・
USB format
：
Prepare a USB memory formatted in FAT16 or FAT32.
Note
：
・
Do not run the USB memory through a hub.
・
Do not connect a computer to the USB port of this unit using a USB cable.
・
Do not use an extension cable when connecting the USB unit.
4.2. CreatingaserviceReleaseTypesettingle
(1) On the PC, click [Start button] – [Accessories] – [notepad] to start the notepad application.
(2) Enter 'TEXT'.
(3) Click the "File" and Click the "Save As..." button.
(4) Input File name "aios-cong-release-type-set-3" and Click Save button.
Note
：
Typing the le name surrounded by double quotes.(No need le extention)
(5) Copy the created le to the USB memory.
4.3. Insert the USB memory in the USB port
(1) I nsert the USB ash memory that contains the le created in the steps above to the USB slot on the back panel of this
unit.
(2) Check that the LED on the front panel of this unit is Blue ashing, and then remove the USB ash memory.
The service Release Type settings are complete.
"aios-cong-release-type-set-3"
copy to USB flash drive
aios-cong-release-type-set-3
22