EasyManuals Logo

Denon RCD-N10 User Manual

Denon RCD-N10
79 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #76 background imageLoading...
Page #76 background image
5. Normal Firmware Update Method from USB Flash Drive (IC20, NETWORK MODULE)
5.1. File structure on USB ash drive
Copy the normal update les onto the USB ash drive in the following structure.
After unzipping the HW component USB update les for the target model and LEGO USB update les,
store them in the root of the same USB ash drive.
Model Area
Download from SDI
For HW component For LEGO component
North America (E3)
DPMS_RCDN10ALL_LEGO_xxx.zip
Product ID : 000200200100
heos_40.prod_x.xxx.xx.zip
Europe (E2)
DPMS_RCDN10ALL_LEGO_xxx.zip
Product ID : 000200200200
China (E1C)
DPMS_RCDN10ALL_LEGO_xxx.zip
Product ID : 000200200500
Japan (JP)
DPMS_RCDN10ALL_LEGO_xxx.zip
Product ID : 000200200400
USB ash drive root
+ RCDN10xx_xxxx.update.auto
+ heos_40.prod.update.x-xxx-xx
5.2. Start normal update
NOTE :
Remove the LAN cable from this unit when updating.
(Do not connect to a wired or wireless network.)
Do not remove the USB ash drive until updating is completed.
Do not turn off the power until updating is completed.
It takes a maximum of approximately 10 minutes for update to complete.
Once an update is started, normal operations cannot be performed until it is completed.
The menu settings and image adjustment settings of this unit may be initialized.
Note down the settings before updating, and set them again after updating.
(1) Press the power operation button to turn off the power, and remove the AC plug from the socket.
(2) Insert the AC plug while pressing button "POWER", and wait for more than 13 seconds.
(3) Release button "POWER" when the power indicator turns white.
Check that the display is as shown below.
(4) Insert the USB ash drive into the USB port.
(5) USB Update starts automatically.
The Standby LED lights red.
Display during USB update
It takes a maximum of approximately 10 minutes for update to complete.
(6) The unit restarts when update is complete.
(7) After updating the rmware, check the version.
See "1-1. Version Display Mode"
Download firmware
in USB flash drive.
Before Servicing
This Unit
Electrical Mechanical Repair Information Updating
76

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon RCD-N10 and is the answer not in the manual?

Denon RCD-N10 Specifications

General IconGeneral
BrandDenon
ModelRCD-N10
CategoryCar Receiver
LanguageEnglish

Related product manuals