21
Barcode Handy Terminal
If Scandisk finds a broken file or files, the screen on the right appears.
(If any broken files exist, the screen on the right appears each time the
BHT starts.)
(Refer to “About “$$BRKLST.SYS” on the following page.)
After a few seconds with the screen displayed, the system starts.
Scandisk when the resume function is enabled
If Scandisk runs when the resume function is enabled, the screen given right may appear.
The BHT disp
lays the scree
n for three seconds and then automatically runs the execution program from
the beginning.
(The screen may also appear when the calendar clock built in the BHT stops, even without running
Scandisk.)
Note The resume function is used to return the display to the status (screen) when the power was last
turned OFF when the power is next turned ON.
Resume function settings are made at the “SET SYSTEM” menu. Refer to “Chapter 4 System
Operation” – “4.5.6 System Environment Settings (SET SYSTEM Menu)” for further details.
To Next Page
Loading...
